MITSUBISHI MR-J2S-55KA4 Manual MR-J2S-55KA4 SUPPLEMENTARY INSTRUCTION MANUAL

Power: 280kw.
Voltage: 200V.
Sine wave filter.
The voltage and current of the motor can be adjusted to a sine wave.
The sine wave filter is installed to the output terminal of the inverter.
Applicable to FR-A820-03800 (75K) above and FR-A840-02160 (75K) and above frequency converter.
Sine wave filter is equivalent to the operational characteristics of the sine wave power driver, can provide the following benefits MR-J2S-55KA4 Manual MR-J2S-55KA4 SUPPLEMENTARY INSTRUCTION MANUAL MR-J2S-55KA4
Low noise.
No surge current.
Reduce motor loss (standard motor). The length of the line: 20M.
Relay type.
IP level: IP20.
Bending life: standard.
Encoder with cable (amplifier side); for HF-KP/HF-MP series. MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 0 MR-J2S-55KA4 Manual MR-J2S-55KA4 SUPPLEMENTARY INSTRUCTION MANUAL. 2kw.
SSCNET interface.
Voltage: single phase AC100V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller MR-J2S-55KA4 Manual MR-J2S-55KA4 SUPPLEMENTARY INSTRUCTION MANUAL.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces the routing time and helps to prevent noise.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servo amplifier, which can form the absolute value system.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use. 1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series.
Rated output: 15.0kw.
Interface: SSCNET III /H.
Power supply: three phase AC400V.
0.6kW and 1kW above the servo amplifier.
Servo amplifier supporting SSCNET III /H.
Complete synchronization system capable of using high speed serial optical communication.
Can be combined with the servo system controller to maximize the performance of the servo system.
The industry''s top level speed motor, the frequency of 2.5kHz amplifier, and optical fiber network extradimensional Symphony orchestra.
Using the traditional two degree of freedom model adaptive control to further optimize the exclusive high speed servo control sstructure of the dedicated execution engine MR-J2S-55KA4 Manual MR-J2S-55KA4 SUPPLEMENTARY INSTRUCTION MANUAL.
Achieved the fastest 2.5kHz speed frequency response in the industry.
Combined with MITSUBISHI independent research and development of hiigh resolution absolute position encoder (4194304pulses/rev),
Greatly improve the processing speed MR-J2S-55KA4 Manual MR-J2S-55KA4 SUPPLEMENTARY INSTRUCTION MANUAL. Can maximize the performance of high-end machinery.