MITSUBISHI MR-J2S-500B-PY096 Manual MR-J2S-500B-PY096 INSTRUCTION MANUAL

MR-J2M multi axis servo amplifier drive unit.
Rated output: 0.2kw.
AC servo control system includes AC servo system based on asynchronous motor and AC servo system based on synchronous motor.
Besides the advantages of good stability, good rapidity and high accuracy, the advantages of.
Its performance indicators can be measured from the speed range, positioning accuracy, the accuracy of stability, dynamic response and operational stability and so on MR-J2S-500B-PY096 Manual MR-J2S-500B-PY096 INSTRUCTION MANUAL MR-J2S-500B-PY096 MITSUBISHI motor universal AC servo amplifier MELSERVO-J3W series (a two axis servo amplifier).
Rated output A axis: 400w.
Rated output B axis: 400w.
Interface type: SSCNET type III fiber communication.
With the same high performance, multi functionality and practicality of the MR-J3-B servo amplifier,
Each MR-J3W-B servo amplifier can be used to rotate the servo motor,
Combined control of any two kinds of linear servo motor and direct drive servo motor MR-J2S-500B-PY096 Manual MR-J2S-500B-PY096 INSTRUCTION MANUAL.
The installation area can be reduced by 25% to 17% compared with two MR-J3-B servo amplifiers.
Therefore, a more compact control system can be constructed.
In addition, the two axes use the same main circuit power supply, control circuit power supply and SSCNET III communication fiber, thus greatly reducing the wiring MR-J2S-500B-PY096 Manual MR-J2S-500B-PY096 INSTRUCTION MANUAL. Content: CNP1 connector, one on the tool.
Purpose: MR-JE-10B to MR-JE-100B, MR-JE-10A to MR-JE-100A with. Drive: MR-H_ACN series built-in positioning function.
Rated output: 5.0KW.
In servo drive speed closed loop,
Rotor speed measurement accuracy is very important to improve the dynamic and static characteristics of the speed control loop.
In order to seek the balance between measurement precision and system cost, incremental photoelectric encoder is generally used as the speed measuring sensor,
The corresponding method is M/T velocity measurement.
Although the M/T measurement method has a certain measurement accuracy and a wide range of measurement,
But this method has its inherent defects,
Mainly includes: the measurement period must be detected at least one complete encoder pulse, limiting the minimum detectable speed.
2 conntrol system for speed control of the timer switch is difficult to maintain synchronization,
Can not guarantee the accuracy of measurement in the situation where the speed change is largger MR-J2S-500B-PY096 Manual MR-J2S-500B-PY096 INSTRUCTION MANUAL MR-J2S-500B-PY096 Manual MR-J2S-500B-PY096 INSTRUCTION MANUAL.
Therefore, it is difficult to improve the speed tracking and control performance of servo drive by using the traditional speed loop design method.