MITSUBISHI MR-J2S-200A4 datasheet PDF catalog MR-J2S-200A4 PDF datasheet

MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.2kw.
Interface type: SSCNET type III fiber communication.
Full closed loop control.
Power specification: single phase AC100V.
High precision and high response location control.
Full closed loop control can be realized by double feedback control method MR-J2S-200A4 datasheet PDF catalog MR-J2S-200A4 PDF datasheet.
Dual feedback control can be performed between the servo motor encoder and the load side encoder MR-J2S-200A4
MR-J3-B-RJ006 can be used in conjunction with a number of manufacturers of linear encoder,
Users can build the system according to their own accuracy requirements. ABS type linear encoder using serial interface,
No need to install the battery on the servo amplifier can easily build the absolute position detection system MR-J2S-200A4 datasheet PDF catalog MR-J2S-200A4 PDF datasheet.
Flexible system configuration.
Can achieve higher load side positioning accuracy!Superior high efficiency IPM motor.
Output power: 7.5kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MR-J2S-200A4 datasheet PDF catalog MR-J2S-200A4 PDF datasheet. Superior high efficiency IPM motor.
Output power: 30kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. Length: 1 meters.
Purpose: MR-JE-A, MR-TB50 connection with. Drive: MR-H_ACN series CC-LINK features.
Rated output: 22KW.
The test system is composed of two parts, namely, the servo driver, the motor system and the host computer.
The host computer sends the speed command signal to the servo driver,
Servo drives start to run in accordance with the instructions.
In the course of operation, the running data of the servo system is collected by the host computer and the data acquisition circuit,
And carries on the preservation, the analysis and the display to the data. Because the motor is not loaded in this test system,
So compared with the previous two kinds of testing systems, the system has a relatively small volume,
And the measurement and control circuit of thhe system is relatively simple,
But it also makes the system can not simulate the actual operation of the servo drive MR-J2S-200A4 datasheet PDF catalog MR-J2S-200A4 PDF datasheet.
Usually, such testing system is only used to test the rotational speeed and angular displacement of the tested system under no-load condition,
And can not carry on the comprehensive and accurate test to the servo drive MR-J2S-200A4 datasheet PDF catalog MR-J2S-200A4 PDF datasheet.