MITSUBISHI FX1S-20MT-DSS Manual FX1S-20MT-DSS HARDWARE MANUAL

Output: 16 points.
Function: transistor output type (drain type).
Corresponding models: FX3GA, FX3G, FX3GE, FX3GC, FX3U, FX3UC.
Can carry on the FX3GC, the FX3UC basic unit and the expansion module or the localization module the connector and the terminal station transformation,
Save the time of the input and output connection, realize the labor saving FX1S-20MT-DSS Manual FX1S-20MT-DSS HARDWARE MANUAL FX1S-20MT-DSS
The use of built-in input and output components models,
Can receive AC100V input, or through the relay or the transistor to drive large capacity load. Max input / output points: 40 points.
Supply voltage: 100 - 240VAC.
Input points: 24 points.
Output points: 16 points.
Output type: transistor.
Power consumption (W): 32.
Weight (kg):0.65.
Size (WxHxD) mm:130x90x75 FX1S-20MT-DSS Manual FX1S-20MT-DSS HARDWARE MANUAL.
Rich functionality.
FX series of products are rich in variety, users can be based on cost or application,
Choose the most suitable product. Will find a suitable model for the user site.
Terminal row type standard machine with extended input output
Can also be less of a system with analog or communication, etc..
CPU, power supply, input and output integration.
Display module or function expansion board can be less installed FX1S-20MT-DSS Manual FX1S-20MT-DSS HARDWARE MANUAL.
In addition, you can also reduce the input output or special module.
Built in 8000 step EPROM memory.
No battery. Maintenance free.
Overseas oriented products meet all kinds of international standards. Power: 0.75kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higherr, it is necessary to take protective measures and cooling FX1S-20MT-DSS Manual FX1S-20MT-DSS HARDWARE MANUAL.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between thhe short circuit chip, in addition to connecting the DC reactor FX1S-20MT-DSS Manual FX1S-20MT-DSS HARDWARE MANUAL.
The installation of thermal relay, to avoid overheating and burn the braking resistor.