MITSUBISHI FX1S-10MT-DSS Manual FX1S-10MT-DSS PROGRAMMING MANUAL II

MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 5.5KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible FX1S-10MT-DSS Manual FX1S-10MT-DSS PROGRAMMING MANUAL II FX1S-10MT-DSS
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used. For a single phase motor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced FX1S-10MT-DSS Manual FX1S-10MT-DSS PROGRAMMING MANUAL II.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft. Station type: intelligent equipment station.
Remote input / output: 128 points.
Remote register: 32.
Occupied points: 8 points.
Transfer speed: 10Mbps.
Power supply: 240mA DC24V.
Weight: 0.3kg.
FX3U-64CCL can be connected to the FX-PLC as an intelligent device station FX1S-10MT-DSS Manual FX1S-10MT-DSS PROGRAMMING MANUAL II.
In addition, through the connection of the various manufacturers of machinery, can be used to set up the system.
Can be connected to FX3GA, FX3GE, FX3GC, FX3U and FX3UC of the host.
Connecting FX3UC, FX3GC requires FX2NC-CNV-IF or FX3UC-IPS-5V. The number of output channels: 4 channels.
Voltage output: DC-10~10V.
Current output: DC0~20mA, DC-4~20mA.
Programmable logic controller: FX2NC, FX3UC.
By using analog input module and output module,
Can be input and output analog (voltage, current, etc.).
Indispensable analog control in FA control,
It is easy to implement on a programmable logic controller. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 7.5kw.
SLD converter rated current: 49A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also throuugh the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FX1S-10MT-DSS Manual FX1S-10MT-DSS PROGRAMMING MANUAL II.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme, used in the control of the external machine FX1S-10MT-DSS Manual FX1S-10MT-DSS PROGRAMMING MANUAL II.
No external PID controller is used to control the external machine, so the system cost can be reduced.