GT1575-VTBA | MITSUBISHI 10.4 inch touch screen GT1575-VTBA

Cable length: 3m.
The connection between the FXCPU communication function extension board (D-SUB9 pin connector) and the GOT/ personal computer (D-SUB9) (GTSoftGOT100 pin).
The connection between the FXCPU communication function adapter (D-SUB9 pin connector) and the GOT.
For personal computer (screen design software) (D-SUB9 pin, the mother''s head) and GOT (D-SUB9 needle, the mother of the head) of the connection between MITSUBISHI GT1575-VTBA GT1575-VTBA
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. Cable length: 10m.
For connection between FXCPU (MINI-DIN8 pin connector) and GOT.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 MITSUBISHI GT1575-VTBA. Cable length: 1.5m.
For the connection between FXCPU and GOT.
Connection between a power supply and an operating switch and a GOT.
Applicable model: HandyGOT. Bus connection (1 channel) unit standard model for QnA/ACPU/ transport controller CPU (A series).
Applicable models: GT15, GT16. Protective film for 3.7 inch screen.
Scrub (frame: white), 5 MITSUBISHI GT1575-VTBA.
Applicable model: GT1020. Optical fiber loop unit.
Applicable models: GT15, GT16, GT27, GT25. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 10.4 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must bbe re calibrated to the touch screen system GT1575-VTBA.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT1575-VTBA.