MITSUBISHI
Home >> Products >> MITSUBISHI >> Touch Screen >> Touch screen accessories >> GOT1000 touch screen accessories >> GT15-70PSGB | MITSUBISHI Resist film GT15-70PSGB

GT15-70PSGB | MITSUBISHI Resist film GT15-70PSGB

MITSUBISHI GT15-70PSGB Manual And Instructions
GT15-70PSGB datasheetPDF datasheet
GT15-70PSGB User's Manual

MITSUBISHI GT15-70PSGB Product information and technical parameters:
Brand: MITSUBISHI
Name: Resist film
Model: GT15-70PSGB
Protective film for 10.4 inch screen.
Scrub, 5.
Applicable model: GT15.

A series of high performance models that are widely used in network or single machine work environments.
Screen size: 10.4 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle) MITSUBISHI GT15-70PSGB.
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422 GT15-70PSGB
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system MITSUBISHI GT15-70PSGB.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MITSUBISHI GT15-70PSGB. Cable length: 5 meters.
For connection between GOT and CRT. Application: you can transfer the same image data at a high speed (about two seconds per 64KB data) to multiple F940GOT.
When programming software is used in the case of Designer2 GT,
You can create a file in HEX Intel format.
Using communication software tto transfer data to a ROM writer GT15-70PSGB.
Application Series: F940GOT. Protective film for 4.7 inch screen.
Transparent (frame: white), 5.
Applicable model: GT104. Cable length: 25 meters.
For QCPU and GOT (need A9GT-QCNB) connection.
For the coonnection between GOT and GOT GT15-70PSGB. Cable length: 1m.
Can be used when the GT15-C / EXSS-1 and GT15-C / BS combination.
Applicable models: GT16, GT15, GT11.


...More relevant models >>>>