MITSUBISHI Q50UDEHCPU SFC Manual Q50UDEHCPU Programming Manual

Input and output points: 1024 points.
Input / output data points: 8192 points.
Program capacity: 60k.
Basic command processing speed (LD command) S:0.2.
PLC in the program execution stage: according to the order of the user program order to store the order of each instruction,
After the corresponding operation and processing, the result is written to the output status register,
The contents of the output status register are changed with the execution of the program Q50UDEHCPU SFC Manual Q50UDEHCPU Programming Manual Q50UDEHCPU
Output refresh phase: when all instructions are executed,
The output status register is sent to the output latch in the output refresh stage,
And through a certain way (relay, transistor or transistor) output, drive the corresponding output equipment Q50UDEHCPU SFC Manual Q50UDEHCPU Programming Manual . "X 10BASE-T/100BASE-T 1 channel.
No need to use PC to meet all the recording needs of the high-speed data recorder module.
High speed, simple, low cost, the accuracy of data records beyond the past.
Can be used to guide the form of a simple set of high speed data recorder module configuration tool",
And display the collected data with the trend chart,
Help to carry out data analysis, etc Q50UDEHCPU SFC Manual Q50UDEHCPU Programming Manual . the recording data display / analysis tool "LogViewer GX"".
By accumulating all kinds of data in the production process,
Not only can help improve the quality of products, reduce production costs, but also for the optimization of the system,
Contribute to the construction of an efficient production site. "MODBUS/TCP Master slave station.
10BASE-T/100BASE-TX.
MODBUS interface module capable of connecting MODBUS compatible device such as temperature regulator, measuring device and so on.
Support MODBUS communication function, and can be compatible with the third party MODBUS to communicate from various station equipment.
Support MODBUS communication functions from the station, can communicate with the third party programmable controller MODBUS master device.
Through the linkage function, the master can be connected to the CH1 siide (RS-232),
And through the QJ71MB91 and connected to the CH2 side (RS-422/485) of a number of stations for communication Q50UDEHCPU SFC Manual Q50UDEHCPU Programming Manual .
The RS-232 interface (1 credit on the 1 pass) MODBUS master device withh multiple MODBUS communication from the station equipment Q50UDEHCPU SFC Manual Q50UDEHCPU Programming Manual . (only QJ71MB91)
Master / slave station functions can be used simultaneously. (only QJ71MT91)