MITSUBISHI Q25HCPU Communication Protocal Manual Q25HCPU Reference Manual

Master station module supporting AnyWireASLINK system.
Connecting sensor and programmable controller.
Free configuration of sensors, control of 512 points of the input and output.
The AnyWireASLINK transmission line (2 lines) can be used for communication to supply power for the sensor, and the sensor can also be conveniently added Q25HCPU Communication Protocal Manual Q25HCPU Reference Manual.
Can through the project software GXWorks2 batch management sensor shedding detection and from the station module settings, etc Q25HCPU,
Substantial savings in time and cost.2 channel.
Input: DC4~20mA (connecting two wire transmitter); DC0~20mA.
Output (resolution): 0~4000. 0~12000.
Conversion speed: 10ms/ channel.
40 pin connector.
Isolation between channels.
Power supply to a two wire transmitter Q25HCPU Communication Protocal Manual Q25HCPU Reference Manual.
The possibility of expanding control with intelligent function.
At the same time, the channel isolation analog module realizes high isolation voltage,
Further improve the accuracy of the benchmark.
Provide support for process control using a general purpose programmable controller.
Flow meter, pressure meter, other sensors can be directly connected to analog input,
Control valve can also be directly connected to analog output Q25HCPU Communication Protocal Manual Q25HCPU Reference Manual.
Hardware and installation costs have been greatly reduced due to the need for an external isolation amplifier.
High insulation strength.
Can isolate electrical interference, such as current and noise, etc..
Standard analog input module.
Isolated analog input module.
No external isolation amplifier required.
Without the use of inter channel isolation analog modules.
Using the inter channel isolation analog module.Connect to read and write 2Ch.
ID system interface module.
ID controller M-688-001/002 BIS can be installed directly to the Q series of substrates,
Control module for reading and writing ID tag data through a programmable logic controller.
The ladder diagram of M-688-002 BIS is compatible with QD35ID1/2.
2 aantennas can be connected, and the parallel processing of the 2 channels can be simultaneously carried out Q25HCPU Communication Protocal Manual Q25HCPU Reference Manual.
Can use all ID tags in the M BIS series.
ID series /BIS system is an industriaal automation ID system which can use the electromagnetic combination method to read and write data Q25HCPU Communication Protocal Manual Q25HCPU Reference Manual.
ID tag has a variety of sizes and storage capacity.