MITSUBISHI Q12PRHCPU Common Instruction 1/2 Manual Q12PRHCPU Programming Manual

"Maximum control axis: 16 axis.
Connection mode with servo amplifier: SSCNET III /H connection type.
The maximum distance between the drive units: 100m.
Operation cycle: 0.88ms, 1.77ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 4 points.
Color detecting set: 16 set Q12PRHCPU Common Instruction 1/2 Manual Q12PRHCPU Programming Manual.
Even the long distance wiring can be flexible Q12PRHCPU
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc Q12PRHCPU Common Instruction 1/2 Manual Q12PRHCPU Programming Manual. .
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus greatly reducing wiring Q12PRHCPU Common Instruction 1/2 Manual Q12PRHCPU Programming Manual.
In addition to positioning control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc..
Positioning module (QD75MH) of the project and the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS). "Control axis: maximum 8 axes.
Greater flexibility.
PLC control and motion control using independent CPU, optimize the system configuration.
More than 4 CPU modules can be freely selected in multi CPU system.
MITSUBISHI SSCNET control function.
By using the high speed serial communication mode, we can easily construct the synchronization system of the servo motor.
The motion controller and the servo amplifier can be quickly connectedd by a connector, and the connection is simplified Q12PRHCPU Common Instruction 1/2 Manual Q12PRHCPU Programming Manual.
Each 1 CPU can control up to 32 axes at the same time.
Can control the small capacity from 10W to 55KW large capacity servo motoor Q12PRHCPU Common Instruction 1/2 Manual Q12PRHCPU Programming Manual.
Through the use of digital oscilloscope function, can be used to control the power distance, speed, position and other motor information monitoring.