MITSUBISHI Q00UJCPU-SET Special Instructions Manual Q00UJCPU-SET Strctured Programming Manual

The telephone line of the interface module is connected with the peripheral equipment.For 32 point I/O. 0.5 square mm (AWG20).Three-phase 4 wire type.
Measuring circuit number: 1 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc..
Power measurement module product group capable of simply measuring various energy information Q00UJCPU-SET Special Instructions Manual Q00UJCPU-SET Strctured Programming Manual Q00UJCPU-SET
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information.
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm Q00UJCPU-SET Special Instructions Manual Q00UJCPU-SET Strctured Programming Manual.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment.
3 phase 3 wire products can be used to measure up to 4 circuits in one slot,
3 phase 4 wire products can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products Q00UJCPU-SET Special Instructions Manual Q00UJCPU-SET Strctured Programming Manual.
For example, a module can be used to measure other loads from the control panel trunk.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.BASIC program execution module.
RS-232.
2 channel.
Ultra high speed processing, production time is shortened, better performance.
As applications become larger and more complex, it is necessary to shorten the system operation cycle time.
The operation period can be shortened by the super high basic operation speed 1.9ns.
In addition to achieve in the past with the control of single-chip high-speed control,
The system performance can be improved by reducing the total scan time,
To prevent any possible perfoormance bias Q00UJCPU-SET Special Instructions Manual Q00UJCPU-SET Strctured Programming Manual.
The position signal of the first axis servo amplifier, which is used on the motion CPU, is used as a trigger,
Starting from the programmable controller CPU to the second axis servo amplifier,
Time to output speed command of servo amplifier Q00UJCPU-SET Special Instructions Manual Q00UJCPU-SET Strctured Programming Manual.
This time is the index of data transmission speed between CPU.