MITSUBISHI Q00JCPU SFC Manual Q00JCPU Programming Manual

Control axis: up to 16 axes.
Servo amplifier connection mode: SSCNET III /H (1 system).
Motion controller is a CPU module that is used in combination with a programmable controller CPU.
Control the programmable controller CPU independently by using motion SFC program.
High precision motion control can be carried out with the programmable controller CPU to share the load Q00JCPU SFC Manual Q00JCPU Programming Manual Q00JCPU
Implementation of high precision motion control for position tracking and series operation.
Can be directly on the input and output modules, analog module, high-speed counter module, such as management, to achieve high-speed input and output.Cable length 0.6 meters.
Extended substrate for connection.Output points: 32 points Q00JCPU SFC Manual Q00JCPU Programming Manual .
Output voltage and current: DC5 ~ 24V0.2A/1 point.
2A/1 common end.
Response time: 2 s; 32 1 public end leakage.
40 pin connector.
Continue to go beyond, to climb the peak of Q series.
Strengthen security function.
Can be set up to 32 characters of the file password.
In addition to the English letters, numbers, but also the use of special characters,
To further enhance the security of the password Q00JCPU SFC Manual Q00JCPU Programming Manual .
In addition, only pre registered devices are allowed to access CPU,
To intercept unauthorized access to unauthorized users.
Therefore, it is important to prevent the outflow of important program assets and protect intellectual property rights.
A variety of modules with excellent performance,
Meet the needs of various control from analog to location.
Q series module products include a variety of types of I/O, analog and positioning function module.
Can fully meet the switch, sensor, such as the input and output, temperature, weight, flow and motor, drive control,
As well as the requirements of high-precision control of the positioning of the industry, the control needs of various fields.
Can also be used in combination with the CPU module to achieve appropriate control.
Easy connection programming tool via ethernet.
Programming tools (Works2 GX, Developer GX) and CPU ddirect connection (1 to 1),
No need to carry out the IP address settings Q00JCPU SFC Manual Q00JCPU Programming Manual . And there is no need to select the cable, the straight line and the cross line can be used.
Therefore, this connection method annd the use of USB, can easily communicate with the CPU,
Even the operators are not familiar with the network settings can easily establish a connection Q00JCPU SFC Manual Q00JCPU Programming Manual .