MITSUBISHI MR-J3-200AN Manual MR-J3-200AN INSTRUCTION MANUAL

The length of the line: 2m.
IP level: IP67.
Bending life: high bending life.
Encoder cable for HF-KP/HF-MP/HF-SP/HF-JP/HC-LP/HC-UP series. Type: MR-J series.
Rated output: 1.0KW.
Applicable motor series: HA-FF, HA-SE.
Voltage: three phase AC220V.
It is very helpful to improve the stability of the low speed control of the servo motor MR-J3-200AN Manual MR-J3-200AN INSTRUCTION MANUAL.
But there is no direct effect to improve the accuracy of position control MR-J3-200AN
There are, of course, software compensation that is similar to pitch compensation,
Can improve the physical resolution of the single lap, so as to improve the accuracy of positioning control.
This can be effectively used in the use of the robot control of the indexing table.
It is also because of the application of splicing technology,
The rotary encoder will be more widely used in the high precision servo control in the harsh environment MR-J3-200AN Manual MR-J3-200AN INSTRUCTION MANUAL.
The use of rotary encoder with 224/ in the servo motor has been used in the servo motor.
Encoder serial communication system, the communication frequency can only be limited to 10M. Superior high efficiency IPM motor.
Output power: 30kw.
Rated speed: 1500r/min MR-J3-200AN Manual MR-J3-200AN INSTRUCTION MANUAL.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. MITSUBISHI universal AC servo amplifier MELSERVO-JE series.
Rated output: 0.2kw.
Interface: General purpose.
Compatible motor: HG-KN23J-S100, HG-KN23BJ-S100.
MR-JE-A is equipped with a positioning function!
Be able to realize the positioning of the point set list and the way of the program.
At the same time, it also has a simple cam, encoder to follow, mark deteection and other equipment can achieve high performance of the advanced functional group MR-J3-200AN Manual MR-J3-200AN INSTRUCTION MANUAL.
Without positioning module, the controller can build a positioning system, which can simplify the system.
Coommand interface using DI/O and RS-422/RS-485 serial communication (maximum 32 axis),
Can simply set the positioning data through the Configurator2 MR MR-J3-200AN Manual MR-J3-200AN INSTRUCTION MANUAL.