MITSUBISHI FX3U-80MR/DS Basic & Applied Instructions Edition Manual FX3U-80MR/DS PROGRAMMING MANUAL

MITSUBISHI inverter series: FR-F840.
Voltage level: three phase 400V.
Power: 280kw.
SLD converter rated current: 610A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
The motor efficiency is not changed in the previous optimal excitation control,
At the same time, the newly developed advanced optimal excitation control can obtain larger torque at startup FX3U-80MR/DS Basic & Applied Instructions Edition Manual FX3U-80MR/DS PROGRAMMING MANUAL FX3U-80MR/DS
No need to adjust the parameters (plus deceleration time or torque, etc.), in a short time to speed up to a certain speed,
Can be carried out to maximize the efficiency of energy-saving drive motor.
The automatic tuning function of the loop constant of the motor is not consistent with the constant of the motor, the motor of other manufacturers, and the length of wiring is too long,
Optimum operating characteristic drive motor FX3U-80MR/DS Basic & Applied Instructions Edition Manual FX3U-80MR/DS PROGRAMMING MANUAL.
In the state of the sensor can not only drive the high efficiency and energy saving motor and PM motor (MM-EFS), but also can drive other companies induction motor and PM motor (permanent magnet synchronous motor).
Other manufacturers of induction motors, can also be automatically tuned to achieve the best excitation control, thus expanding the use of energy saving FX3U-80MR/DS Basic & Applied Instructions Edition Manual FX3U-80MR/DS PROGRAMMING MANUAL. Max input / output points: 14 points.
Power supply voltage: DC24V.
Input points: 8 points.
Output points: 6 points.
Output type: relay.
Power consumption (W): 19.
Weight (kg):0.3.
Size (WxHxD) mm:60x90x75.
Positioning and pulse output functions: a PLC cell can output 2 point 100KHz pulses at the same time.
PLC is equipped with 7 special positioning instructions,
Including zero return, absolute or relative address expression and special pulse output control.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLCC, can be output 2 100KHz pulse, direct drive servo or stepper motor FX3U-80MR/DS Basic & Applied Instructions Edition Manual FX3U-80MR/DS PROGRAMMING MANUAL.
The series PLC can not be brought with the expansion module, but can be installed by the BBD board to extend a small amount of I/O FX3U-80MR/DS Basic & Applied Instructions Edition Manual FX3U-80MR/DS PROGRAMMING MANUAL.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication.