MITSUBISHI FX3U-64CCL Manual FX3U-64CCL INSTALLATION MANUAL

Power: 55kw.
Voltage: 200V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connected without built-in brake transistor inverter.
Three types of discharge resistors are available FX3U-64CCL Manual FX3U-64CCL INSTALLATION MANUAL.
Please select according to the required braking torque FX3U-64CCL Input and output points: 40 points.
Power supply: DC24V.
Input points: 24 points.
Output points: 16 points.
Output form: relay output.
Power consumption: 25W.
Weight: 0.7KG.
Outline dimension: 130x90x86mm.
FX3GE on the performance of the FX3GA increased analog input / output and Ethernet communication and other built-in features.
Applicable to a wide variety of applications FX3U-64CCL Manual FX3U-64CCL INSTALLATION MANUAL.
Basic unit: 24/40 point.
Third generation standard model.
High flexibility.
Suitable for small scale control of high cost PLC.
Control points to 128 points, the use of CC-Link remote I/O can control the maximum 256 points.
A versatile PLC.
Built in CPU, power supply, input and output, analog input and output, Ethernet port, can be used immediately after the purchase FX3U-64CCL Manual FX3U-64CCL INSTALLATION MANUAL.
High speed operation.
Basic instructions: 0.21 s/ instruction.
Application instruction: 0.5 s/ instruction.
Large capacity memory.
Built in program memory 32000 steps.
EEPROM memory cartridge with program transfer function. RS-485 communication adapter.
(need FX1N-8AV-BD).
(FX1S and FX1N host general). Power: 160kw.
Voltage: 400V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 1.5kw.
SLD converter rated current: 10.5A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but allso through the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FX3U-64CCL Manual FX3U-64CCL INSTALLATION MANUAL.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme, used in the control of the external machine FX3U-64CCL Manual FX3U-64CCL INSTALLATION MANUAL.
No external PID controller is used to control the external machine, so the system cost can be reduced.