MITSUBISHI FX3U-16MR/ES-A Manual FX3U-16MR/ES-A HARDWARE MANUAL

The largest input / output points: 20 points.
Power supply voltage: 24VDC.
Input points: 12 points.
Output points: 8 points.
Output type: Transistor (source).
Power consumption (W): 7.
Weight (kg):0.3.
Size (WxHxD) mm:75x90x49.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14 FX3U-16MR/ES-A Manual FX3U-16MR/ES-A HARDWARE MANUAL FX3U-16MR/ES-A
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator.
MITSUBISHI FX1S series PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0.
FX1S provides up to 30 I/O points, and can be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FX3U-16MR/ES-A Manual FX3U-16MR/ES-A HARDWARE MANUAL. Function: input / output module (internal service power supply).
Input / output points: 32 points
Input points: 16 points.
Output points: 16 points.
DC5V internal consumption current: 965mA.
DC24V internal consumption current: 250mA FX3U-16MR/ES-A Manual FX3U-16MR/ES-A HARDWARE MANUAL.
Input / output mode: DC input (drain / source) / transistor (source).
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points. Max input / output points: 20 points.
Power supply voltage: DC24V.
Input points: 12 points.
Output points: 8 points.
Output type: relay.
Power consumption (W): 20.
Weight (kg):0.4.
Size (WxHxD) mm:75x90x75.
Positioning and pulse output functions: a PLC cell can output 2 point 100KHz pulses at the same time.
PLC is equipped with 7 special positioning instructions,
Including zero return, absolute or relative address expression and special pulse output control.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The seriees transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor FX3U-16MR/ES-A Manual FX3U-16MR/ES-A HARDWARE MANUAL.
The series PLC can not be brought with the expansion module, but can be installed by the BBD board to extend a small amount of I/O FX3U-16MR/ES-A Manual FX3U-16MR/ES-A HARDWARE MANUAL.
The series 1N through the installation of BD series PLC board, can achieve RS232, RS485, RS422 communication.