MITSUBISHI FX3U-48MT/DS Positioning Control Edition Manual FX3U-48MT/DS USER'S MANUAL

Length: 1 meters.
Operation panel or parameter unit connection line. 8 point analog potentiometer function expansion board.Max input / output points: 64 points.
Supply voltage: 100 - 240VAC.
Input points: 32 points.
Output points: 32 points.
Output type: relay.
Power consumption: 60VA.
Weight (kg):1 FX3U-48MT/DS Positioning Control Edition Manual FX3U-48MT/DS USER'S MANUAL. 0.
Size (WxHxD) mm:220x90x87 FX3U-48MT/DS
Note recording function, Component annotation can be recorded in the program register.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program FX3U-48MT/DS Positioning Control Edition Manual FX3U-48MT/DS USER'S MANUAL.
Clock function and hour meter function, all of the PLC FX2N has a real-time clock standard.
Continuous scanning function, to define the operation cycle for the application of the continuous scan time.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017) FX3U-48MT/DS Positioning Control Edition Manual FX3U-48MT/DS USER'S MANUAL. Input signal: platinum temperature resistance 3 wire 4 points.
Sensor current: 1mA.
Applicable PLC:FX1N, FX2N, FX3U, FX2NC (to FX2NC-CNV-IF).
Applicable PLC:FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V).
PT type temperature sensor input module.
Platinum temperature measurement resistor (Pt100 3 wire) temperature sensor input module.
4 channels can be entered.
Unit can be set to Celsius or fahrenheit.
Resolution is 0.2~0.3 degree of high precision. Needle number: 40.
Specification: loose wire connector, 5 sets (0.3mm 2). MITSUBISHI inverter FR-D740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 0.75KW.
The internal and back of the inverter structure considering the cooling effect, the relationship between the upper and lower ventilation is also important,
Therefore, in order for the type of unit, hanging on the wall to the vertical position, the installation of vertical as possible.
Transducer can be used to drive a single phase motor? Can single phase power supply be used?
Basically can not be used. For a single phase mottor with governor switch, the auxiliary winding will be burnt when the speed is below the operating point;
For the capacitor start or capacitor operation mode, the capacitor explosion will be induced FX3U-48MT/DS Positioning Control Edition Manual FX3U-48MT/DS USER'S MANUAL FX3U-48MT/DS Positioning Control Edition Manual FX3U-48MT/DS USER'S MANUAL.
The inverter power supply is usually 3, but the capacity for small, single-phase power is also useful functioning aircraft.