MITSUBISHI FX3G-40MT/DS Hardware Edition Manual FX3G-40MT/DS USER'S MANUAL

Input points: 32 points.
Connected programmable logic controller: FX1NC, FX2NC, FX3UC.
Weight: 0.2KG.
FX2NC expansion module can be directly connected to the FX1NC, FX2NC, PLC FX3UC on the expansion of the input and output.
Do not need to connect the cable and so on, therefore can carry on the compact expansion FX3G-40MT/DS Hardware Edition Manual FX3G-40MT/DS USER'S MANUAL. Can be isolated from the output of the programmable controller, the a/b/c contact relay, SSR, Tr output FX3G-40MT/DSMITSUBISHI inverter series: FR-A800.
Voltage level: three phase 400V.
Power: 355kw.
SLD converter rated current: 866A.
Structure and function: the rectification part is off type.
Type: CA.
Substrate coating: have.
To maximize the performance of the motor.
Advanced auto tuning function FX3G-40MT/DS Hardware Edition Manual FX3G-40MT/DS USER'S MANUAL.
The newly developed PM motor auto tuning feature can be used to operate other manufacturers of PM motors (Yong Ci synchronous motors) in the sensorless state.
Not only can drive MITSUBISHI induction motor and PM motor, but also can drive other manufacturers of induction motor and PM motor.
This means that you can reduce the cost of inventory and supplies.
If the PM motor is produced by a IPM motor or other company using MM-CF, the starting torque is limited to 50%,
Even after tuning is not simple to use and positioning control of zero speed torque) induction motor and permanent magnet motor can be combined freely FX3G-40MT/DS Hardware Edition Manual FX3G-40MT/DS USER'S MANUAL. Maximum frequency: 200kHz.
Input points: 2 points.
Output form: transistor 4 point output.
Weight: 0.2kg.
1 FX3U-2HC can enter the 2CH high speed signal, can achieve the maximum count of 200kHz.
Through the comparison of the value of the PLC set, each ch with 2 points of high-speed output terminal.
In the 2 phase count, can be set 1, 2, 4 frequency.
Can be achieved by PLC or external input to count the licensing / prohibition.
Can also be connected to the linear drive output type of the encoder.
FX3UC host connected to the FX2NC-CNV-IF, the need for FX3U-2HC or FX3UC-IPS-5V. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 0.75kw.
SLD converter rated current: 7.7A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also through thee use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FX3G-40MT/DS Hardware Edition Manual FX3G-40MT/DS USER'S MANUAL.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme, used in the control of the external machine FX3G-40MT/DS Hardware Edition Manual FX3G-40MT/DS USER'S MANUAL.
No external PID controller is used to control the external machine, so the system cost can be reduced.