MITSUBISHI FX2N-10PG Manual FX2N-10PG USER'S MANUAL

MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 45KW.
Frequency converter common frequency of a given way: the operator keyboard is given, the contact signal given, analog signal given, the pulse signal given and communication methods given, etc..
These frequencies have their advantages and disadvantages, and should be selected according to the actual needs FX2N-10PG Manual FX2N-10PG USER'S MANUAL FX2N-10PG
Frequency converter is a power control device which uses the power of the power semiconductor device to change the power frequency to another frequency,
Can realize the asynchronous motor soft start, variable frequency speed regulation, improve the operation precision, change the power factor, over current / over voltage / overload protection and other functions FX2N-10PG Manual FX2N-10PG USER'S MANUAL. Power: 7.5kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FX2N-10PG Manual FX2N-10PG USER'S MANUAL.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Application: you can transfer the same image data at a high speed (about two seconds per 64KB data) to multiple F940GOT.
When programming software is used in the case of Designer2 GT,
You can create a file in HEX Intel format.
Using communication software to transfer data to a ROM writer.
Application Series: F940GOT. Output points: 32 points
Output form: Transistor (drain typpe) FX2N-10PG Manual FX2N-10PG USER'S MANUAL.
Connection status: connector.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion modulee: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points FX2N-10PG Manual FX2N-10PG USER'S MANUAL.