Long distance bus connection for QnA/ACPU.
Applicable models: GT16, GT15, GT11. Cable length: 0.7 meters
Extending cable to connect CPU main substrate and extended substrate,
According to the model can provide different cable length,
If you need to connect the AnN type expansion substrate is required,
Selection of A1SC05NB (A1SC07NB) cable A985GOT-TBD Extended/Option Functions Manual Manual A985GOT-TBD Operating Manual
A985GOT-TBD Points: 32 points
.
Rated voltage: DC24V.
Connection type: connector
.
Three remote components can be connected to the CC-LINK system.
Remote I/O: refers to those who require only the ON/OFF control function of the field components, such as digital I/O or pneumatic valve, etc..
In this type of communication can only be carried out in the bit data.
Remote components: refers to those that require processing of the register data of the field components, such as analog I/O and counters, etc A985GOT-TBD Extended/Option Functions Manual Manual A985GOT-TBD Operating Manual. .
In this type of component, in addition to the bit data can be carried out in the register data communication.
Intelligent remote: this type of component is to allow the main station or other stations to access the action, to collect data and control the local PLC station,
GOTS and programmer interface unit are of this type A985GOT-TBD Extended/Option Functions Manual Manual A985GOT-TBD Operating Manual. QnA/ACPU bus connection.
2 joint.
Applicable models: A985 (-V) /975/970/960GOT. Output type: transistor output, source.
Output points: 16 points.
OFF leakage current: 0.30mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.1A.
External connection: 2 wire.
Waterproof connector type.
Strong waterproof type of IP67 protection grade.
No need to stop the system can be replaced module.
Without the use of tools can be a simple connection, save time.
Terminal resistor built-in.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in thee MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy too guarantee the timeliness A985GOT-TBD Extended/Option Functions Manual Manual A985GOT-TBD Operating Manual A985GOT-TBD Extended/Option Functions Manual Manual A985GOT-TBD Operating Manual.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer.