MITSUBISHI A273UHCPU-S3 SV13/22 SFC Manual A273UHCPU-S3 Programming Manual

Output type: transistor output, drain type.
Output points: 16 points.
OFF leakage current: 0.25mA.
Output protection function.
Rated load voltage / current: DC12V/DC24V/0.5A.
External connection: 2 wire.
Waterproof connector type.
Strong waterproof type of IP67 protection grade.
No need to stop the system can be replaced module A273UHCPU-S3 SV13/22 SFC Manual A273UHCPU-S3 Programming Manual.
Without the use of tools can be a simple connection, save time A273UHCPU-S3
Terminal resistor built-in.
Can be installed along the 6 direction.
Hardware simulation method is to use a number of hardware equipment to simulate the generation of the signal,
The signals are connected to the input end of the PLC system in a hard wired way, and the timeliness is strong.
Software simulation method is in the MITSUBISHI PLC in the preparation of a set of simulation program,
The simulation provides the field signal, which is simple and easy to operate, but it is not easy to guarantee the timeliness A273UHCPU-S3 SV13/22 SFC Manual A273UHCPU-S3 Programming Manual.
Simulation of the process of debugging, debugging method can be used to segment, and the monitoring function of programmer. RS-422 1 channel.
Transfer speed: 38.4kbps.
Link points, 512 points A273UHCPU-S3 SV13/22 SFC Manual A273UHCPU-S3 Programming Manual.
The connection number: 8, 500m.
How to determine the input / output device of MITSUBISHI plc.
According to the control requirements of the system,
All input devices and output devices required for the determination of the system,
To determine the input / output device related to the MITSUBISHI PLC,
To determine the I/O PLC points.
Detailed analysis of the process and work characteristics of the controlled object,
To understand the coordination between the controlled object machine, electricity and liquid,
The control requirements of the controlled object for MITSUBISHI PLC control system are put forward,
Determine the control program, to develop a design task book. CPU connection program input device.
ACPU use. 3C-2V/5C-2V coaxial cable.
Single bus.
PC inter network (management station / station) / remote I/O network (remote control station).
How to choose MITSUBISHI PLC.
MITSUBISHI PLC options include the choice of MITSUBISHI PLC models, capacity, I/O module, power, etc..
MITSUBISHI PLC distribution I/O points and design MITSUBISHI PLC peripheral hardware circuit
Draw the I/O point of the PLC and the input / output device connection diagram or the corresponding table,
This part also can be carried out in second steps.
Design PLC peripheral hardware circuit.
Draw the electrical wwiring diagram of the other parts of the system,
Including the main circuit and the control circuit does not enter the PLC, etc A273UHCPU-S3 SV13/22 SFC Manual A273UHCPU-S3 Programming Manual. .
The electrical schematic diagram of the system compoosed of I/O PLC connection diagram and PLC peripheral electrical circuit diagram A273UHCPU-S3 SV13/22 SFC Manual A273UHCPU-S3 Programming Manual.
So far the system''s hardware electrical circuit has been determined.