MITSUBISHI MR-JCCBL30M-L datasheet PDF catalog MR-JCCBL30M-L PDF datasheet

Superior high efficiency IPM motor.
Output power: 22kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MR-JCCBL30M-L datasheet PDF catalog MR-JCCBL30M-L PDF datasheet. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series MR-JCCBL30M-L
Rated output: 2.0kw.
Interface type: SSCNET type III fiber communication.
Special specification: suitable for direct drive servo motor.
Power specification: three phase AC200V.
Direct drive system suitable for high speed and high precision!
High speed operation can be realized by direct drive (2m/s), and the traditional mechanical transmission can not achieve such a high speed MR-JCCBL30M-L datasheet PDF catalog MR-JCCBL30M-L PDF datasheet.
The full closed loop control can be realized by using the position feedback signal from the load side encoder, such as the linear encoder.
The use of a flexible linear servo motor drive components can make the system more compact structure.
The primary side of the linear servo motor (motor coil) is sliding along the secondary side (permanent magnet) of the motor,
So linear servo motor is especially suitable for large range of applications MR-JCCBL30M-L datasheet PDF catalog MR-JCCBL30M-L PDF datasheet. In addition, linear servo motor can be connected in series,
Especially for large systems in two axes for high precision synchronous operation. For HF-KP/HF-MP series"MITSUBISHI general purpose AC servo amplifier MELSERVO-J2-Super series.
Rated output: 0.2kw.
SSCNET interface.
Voltage: single phase AC100V.
Complete synchronization system with SSCNET high speed serial communication,
The communication cycle between the controller and the servo amplifier is the longest 0.888ms.
Such systems will be able to provide high reliability and high performance.
When connecting the servo system with SSCNET,
In the motion system, the parameters of the servo amplifier and the acquisition of the data will be displayed on the motion controller.
Connect a dedicated cable with an amplifier and a controller to form a SSCNET system.
This simple connection method reduces the routing time and helps to pprevent noise MR-JCCBL30M-L datasheet PDF catalog MR-JCCBL30M-L PDF datasheet.
Even in the MELSERVO-J2-SUPER series products using high resolution coding standards, the command frequency is no limit.
It is only necessary to add a battery on the servvo amplifier, which can form the absolute value system MR-JCCBL30M-L datasheet PDF catalog MR-JCCBL30M-L PDF datasheet.
Currently there are more than 1000000 high reliability SSCNET servo amplifier networks in use. "