MITSUBISHI MR-J3-15KB-RJ006 datasheet PDF catalog MR-J3-15KB-RJ006 PDF datasheet

MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.6kw.
Interface type: SSCNET type III fiber communication.
Power specification: three phase AC400V.
High speed serial communication between the SSCNET and the servo amplifier by using the fastest up to 0.44ms communication cycle,
A fully synchronous control system can be constructed MR-J3-15KB-RJ006 datasheet PDF catalog MR-J3-15KB-RJ006 PDF datasheet MR-J3-15KB-RJ006
It is only necessary to insert the special optical fiber into the joint to form SSCNET III network, which greatly reduces the wiring work and reduces the possibility of false wiring.
Due to the adoption of the optical fiber communication, the anti noise ability can be greatly improved and the long distance wiring of 50 meters (maximum 800 meters x 16 axes) can be realized MR-J3-15KB-RJ006 datasheet PDF catalog MR-J3-15KB-RJ006 PDF datasheet.
A servo amplifier to meet the full closed loop control function MR-J3-B-RJ006.
Suitable for mechanical servo optimization and adjustment!
More advanced optimization adjustment function and control function to maximize mechanical properties. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.2kw.
Interface type: CC-Link communication type (built-in positioning function) MR-J3-15KB-RJ006 datasheet PDF catalog MR-J3-15KB-RJ006 PDF datasheet.
Power specification: single phase AC100V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations.
Serial communication reduce wiring.
Diistributed servo control system can be built by CC-Link communication MR-J3-15KB-RJ006 datasheet PDF catalog MR-J3-15KB-RJ006 PDF datasheet.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J3-15KB-RJ006 datasheet PDF catalog MR-J3-15KB-RJ006 PDF datasheet.
When the two stations are occupied, the speed can be set directly by the remote register.