MITSUBISHI MR-J3-100T4 datasheet PDF catalog MR-J3-100T4 PDF datasheet

Type: general purpose AC servo amplifier MR-E series.
Rated output: 1.0kw.
Interface type: analog input interface.
KH003 special mark for Super MR-E.
Servo amplifier terminals are used to reduce the required wiring time.
The connector is located in front of the servo amplifier, which is convenient for cable connection MR-J3-100T4 datasheet PDF catalog MR-J3-100T4 PDF datasheet.
The gain adjustment can be easily carried out by the real-time automatic tuning function MR-J3-100T4
Wide use.
Machining equipment and machine tool feed.
Used for food, packaging equipment and feeding device.
For textile machinery, etc..
Can improve the performance of equipment. Superior high efficiency IPM motor.
Output power: 37kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power MR-J3-100T4 datasheet PDF catalog MR-J3-100T4 PDF datasheet.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 5.0kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: three phase AC200V MR-J3-100T4 datasheet PDF catalog MR-J3-100T4 PDF datasheet.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations.
Serial communication reduce wiring MR-J3-100T4 datasheet PDF catalog MR-J3-100T4 PDF datasheet.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J3-100T4 datasheet PDF catalog MR-J3-100T4 PDF datasheet.
When the two stations are occupied, the speed can be set directly by the remote register.