MITSUBISHI MR-J10B datasheet PDF catalog MR-J10B PDF datasheet

Superior high efficiency IPM motor.
Output power: 30kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MR-J10B datasheet PDF catalog MR-J10B PDF datasheet. 1 axis servo amplifier.
MITSUBISHI general AC servo amplifier MELSERVO-J4 series MR-J10B
Rated output: 7.0kw.
Interface: SSCNET III /H.
Power supply: three phase AC200V.
Special specification: support for CC-LinkIE.Field network motion control.
Servo amplifier supporting IE Field CC-Link network.
Ethernet based open network, support for motion control.
Improve mechanical properties by high performance motor MR-J10B datasheet PDF catalog MR-J10B PDF datasheet.
By improving the resolution and processing speed of the encoder,
The rotating servo motor has higher precision and better performance of rotation.
Only open a key type of adjustment function, can be carried out including mechanical resonance filter, high end seismic control II, low pass filter servo gain adjustment.
Easily start advanced seismic function, it can maximize the mechanical properties MR-J10B datasheet PDF catalog MR-J10B PDF datasheet.
It can automatically adjust the required response settings automatically. The length of the line: 10M.
IP level: IP65.
Direct type.
Bending life: standard.
Connector kit for motor electromagnetic brake.
Cable for electromagnetic brake, for HF-KP/HF-MP series (motor shaft with side extraction). MR-J2M multi axis servo amplifier substrate.
Groove position: 4.
The comparison is to compare the input command signal with the feedback signal of the system in order to obtain the deviation signal between the output and the input,
Usually implemented by a dedicated circuit or computer.
The controller is usually a computer or PID control circuit, and its main task is to transform the deviation signal from the output of the comparator,
To control the execution of components as required. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 0.75kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: single phase AC200V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations.
Serial communicationn reduce wiring MR-J10B datasheet PDF catalog MR-J10B PDF datasheet.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J10B datasheet PDF catalog MR-J10B PDF datasheet.
When the two stations are occupied, the speed can be set directly by the remote register.