MITSUBISHI FX2N-80MR-D datasheet PDF catalog FX2N-80MR-D PDF datasheet

Power: 11kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FX2N-80MR-D datasheet PDF catalog FX2N-80MR-D PDF datasheet.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FX2N-80MR-D
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor FX2N-80MR-D datasheet PDF catalog FX2N-80MR-D PDF datasheet.
The installation of thermal relay, to avoid overheating and burn the braking resistor. MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V.
Frequency converter capacity: 75KW.
Frequency converter common frequency of a given way: the operator keyboard is given, the contact signal given, analog signal given, the pulse signal given and communication methods given, etc FX2N-80MR-D datasheet PDF catalog FX2N-80MR-D PDF datasheet. .
These frequencies have their advantages and disadvantages, and should be selected according to the actual needs.
Frequency converter is a power control device which uses the power of the power semiconductor device to change the power frequency to another frequency,
Can realize the asynchronous motor soft start, variable frequency speed regulation, improve the operation precision, change the power factor, over current / over voltage / overload protection and other functions. Extended power supply for CPU module with built-in power supply.
Bus conversion module is required when using. Maximum can be connected to 2 sets. MITSUBISHI inverter series: FR-F820.
Voltage level: three phase 200V.
Power: 3.7kw.
SLD converter rated current: 25A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Compatibility with existing models.
Transducer installation size and FR-F700 (P) series of the same, so you do not need to worry about the replacement operation.
(rectifier separation type will vary)
Also, but also throughh the use of options (FR-A8TAT), FR-F700 (P) series installed control loop terminal station FX2N-80MR-D datasheet PDF catalog FX2N-80MR-D PDF datasheet.
Built in 2 PID arithmetic. In the inverter can be PID control of the motor state at the same timme, used in the control of the external machine FX2N-80MR-D datasheet PDF catalog FX2N-80MR-D PDF datasheet.
No external PID controller is used to control the external machine, so the system cost can be reduced.