MITSUBISHI FX2N-16EYT-C datasheet PDF catalog FX2N-16EYT-C PDF datasheet

Needle number: 40.
Specification: Cable flat cable connector, supporting 2 sets. Power: 11kw.
Voltage: 200V.
There are 100% braking torque output in continuous regeneration, which can correspond to the continuous regeneration operation of the pipeline control.
There is no need to install the braking unit for each frequency converter, which can reduce the comprehensive space and reduce the comprehensive cost FX2N-16EYT-C datasheet PDF catalog FX2N-16EYT-C PDF datasheet FX2N-16EYT-C
Renewable energy can be used for other frequency converter, excess energy back to the grid, to achieve energy saving. Length: 5 meters.
Operation panel or parameter unit connection line. For FXCPU direct connection.MITSUBISHI inverter series: FR-A800.
Voltage level: three phase 400V.
Power: 400kw FX2N-16EYT-C datasheet PDF catalog FX2N-16EYT-C PDF datasheet.
SLD converter rated current: 962A.
Structure and function: the rectification part is off type.
Type: CA.
Substrate coating: have.
To maximize the performance of the motor.
Advanced auto tuning function.
The newly developed PM motor auto tuning feature can be used to operate other manufacturers of PM motors (Yong Ci synchronous motors) in the sensorless state.
Not only can drive MITSUBISHI induction motor and PM motor, but also can drive other manufacturers of induction motor and PM motor FX2N-16EYT-C datasheet PDF catalog FX2N-16EYT-C PDF datasheet.
This means that you can reduce the cost of inventory and supplies.
If the PM motor is produced by a IPM motor or other company using MM-CF, the starting torque is limited to 50%,
Even after tuning is not simple to use and positioning control of zero speed torque) induction motor and permanent magnet motor can be combined freely. Max input / output points: 20 points.
Supply voltage: 100 - 240VAC.
Input points: 12 points.
Output points: 8 points.
Output type: Transistor (source).
Power consumption (W): 20.
Weight (kg):0.4.
Size (WxHxD) mm:75x90x75.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, the output points are less than 14.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator.
MITSUBISHI FX1S seriies PLC is suitable for the smallest package,
It is the preferred target for low cost users to seek powerful control over a limited range of I/0 FX2N-16EYT-C datasheet PDF catalog FX2N-16EYT-C PDF datasheet.
FX1S provides up to 30 I/O points, and caan be transmitted through serial communication data,
MT models also have the ability to locate, widely used in a variety of small mechanical equipment FX2N-16EYT-C datasheet PDF catalog FX2N-16EYT-C PDF datasheet.