MITSUBISHI FX-20CP-CADP datasheet PDF catalog FX-20CP-CADP PDF datasheet

Input points: 16 points.
Power supply: the basic unit to the expansion module to provide power.
Terminal type: European terminal.
Weight: 0.15kg.
FX3GC, FX3UC can be directly connected to the input and output expansion equipment, to achieve a compact expansion.
Can choose 16 points, 32 points of the relay or transistor input and output models FX-20CP-CADP datasheet PDF catalog FX-20CP-CADP PDF datasheet FX-20CP-CADP
FX2NC-16E_-T-DS for terminal units can be disassembled models. Power: 75kw.
Voltage: 200V.
The power factor of the input power factor is up to 0.99 and above (100% load).
Can be connected to multiple inverters, to achieve a common DC bus mode.
Equipped with standard power retrogradation function. MITSUBISHI inverter series: FR-A820.
Voltage level: three phase 200V FX-20CP-CADP datasheet PDF catalog FX-20CP-CADP PDF datasheet.
Power: 30kw.
SLD converter rated current: 154A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Parameters can be selected by 4 different rated current and different overload rating (SLD (ultra light load) rated, LD (light load) rating, ND (general load) rating, HD (weight).
Type load) for selection.
You can choose the most suitable frequency converter for use; and by selecting a transducer with a SLD or LD rated level,
Be able to reduce the size of the device (compared with the FR-A700 series, to reduce the volume of equipment) FX-20CP-CADP datasheet PDF catalog FX-20CP-CADP PDF datasheet.
For applications that require high torque at low speeds, the HD rating is the most suitable.
The controller is used to control and monitor the frequency converter through the network.
Standard corresponding RS-485 communication (MITSUBISHI converter protocol, Modbus-RTU protocol) data transmission speed up to 115200bps. Cable flat cable;
Connector with 20 pin installed at both ends of the fuse.
Length 1.5M. Can monitor and change the value of the soft component. Can also be simple to operate, change the data.
Can display Japanese and english.
Can be installed directly to the PLC, no wiring.
In addition, the use of FX3U-7DM-HLD, can be directly installed on the electrical cabinets. Power: 22kw.

Purpose: to suppress the power harmonics FX-20CP-CADP datasheet PDF catalog FX-20CP-CADP PDF datasheet.
Connected to the inverter input, can be used to improve the power factor, reduce the input side of the high harmonic current.
According to the mmotor power used to select AC reactor FX-20CP-CADP datasheet PDF catalog FX-20CP-CADP PDF datasheet.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.)