MITSUBISHI FR-F740P-450K-CHT datasheet PDF catalog FR-F740P-450K-CHT PDF datasheet

Total points: 60 points.
Input points: 36 points.
Output points: 24 points.
Voltage: AC220V.
Output type: relay.
Outline dimension: 175*75*90.
FX1N series is a very powerful micro PLC,
Can be extended to up to 128 I/O points,
And can increase the special function module or the expansion board.
Communication and data link function options make FX1N in the volume, communication and special function modules and other important applications is very perfect FR-F740P-450K-CHT datasheet PDF catalog FR-F740P-450K-CHT PDF datasheet FR-F740P-450K-CHT Max input / output points: 48 points.
Supply voltage: 100 - 240VAC.
Input points: 24 points.
Output points: 24 points.
Output type: relay.
Power consumption: 50VA.
Weight (kg):0.85.
Size (WxHxD) mm:182x90x87.
Since the FX2n series have the following features: the maximum range of inclusive of the standard features, program execution faster, the full complement of communication function, suitable for different countries in the world, and the power to meet a large number of special function modules of individual needs,
It can provide maximum flexibility and control capability for your factory automation applications FR-F740P-450K-CHT datasheet PDF catalog FR-F740P-450K-CHT PDF datasheet.
Control 16~256 point FR-F740P-450K-CHT datasheet PDF catalog FR-F740P-450K-CHT PDF datasheet.
Built in 8K capacity of the RAM memory, the maximum can be extended to 16K.
CPU arithmetic processing speed of 0.08 S/ basic instructions.
On the right side of the FX2N series can be connected to the input and output expansion modules and special function modules.
The basic unit is built in the 2 axis independent maximum 20kHz positioning function (transistor output type).
Quick disconnect the terminal block, which adopts excellent maintainability to quickly disconnect the terminal blocks, even if the cable is then replaced by the cable. Power: 11kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary too take protective measures and cooling FR-F740P-450K-CHT datasheet PDF catalog FR-F740P-450K-CHT PDF datasheet.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between thhe short circuit chip, in addition to connecting the DC reactor FR-F740P-450K-CHT datasheet PDF catalog FR-F740P-450K-CHT PDF datasheet.
The installation of thermal relay, to avoid overheating and burn the braking resistor.