MITSUBISHI FR-D740-0.75K-CHT datasheet PDF catalog FR-D740-0.75K-CHT PDF datasheet

Apply PLC:FX2N (up to 3 units), FX3U (up to 3 units).
Applicable PLC:FX2NC (to FX2NC-CNV-IF, up to 1 units), FX3UC (to FX2NC-CNV-IF or FX3UC-1PS-5V, up to 3 units).
The rotation angle detecting unit is controlled by the mechanical cam switch,
The rotation angle is detected by using the special detector, and the rotation position control with high precision is realized FR-D740-0.75K-CHT datasheet PDF catalog FR-D740-0 FR-D740-0.75K-CHT75K-CHT PDF datasheet.
Using the setting unit, it is easy to realize the setting and monitoring of the action resolution.
The detection of rotation angle can be accurate to the high accuracy of 415rpm/0.5 degree or 830rpm/1.0 degree unit.
Built without battery to maintain the EEPROM, the maximum can store 8 kinds of procedures.
The cable that is assembled in the device without the brush can be extended to 100m FR-D740-0.75K-CHT datasheet PDF catalog FR-D740-0.75K-CHT PDF datasheet.
When used alone, the CC-LINK type FX2N-32CCL interface module can be used to connect to the CC-LINK system.
Product composition:
FX2N-1RM: the main body of programmable cam switch (with setting panel).
F2-720RSV: no brush splitter.
FX2N-RS-5CAB: splitter cable (5m).
PLC connecting cable (55mm). A 20 pin connector is installed on one side of the loose line FR-D740-0.75K-CHT datasheet PDF catalog FR-D740-0.75K-CHT PDF datasheet.
Length 5M. Max input / output points: 20 points.
Power supply voltage: 24VDC.
Input points: 12 points.
Output points: 8 points.
Output type: relay.
Power consumption (W): 7.
Weight (kg):0.3.
Size (WxHxD) mm:75x90x49.
Host has 10 points (6I/4O), 14 points (8I/6O), 20 points (12I/8O), 30 points (16I/14O) of 4 types.
This type of PLC is mainly used in all of the digital input, digital output control point of the device.
Can be directly connected to the 220V city power, built-in 8K step EEPROM memory, no battery, easy to maintain.
The series transistor output (MT) of the PLC, can be output 2 100KHz pulse, direct drive servo or stepper motor.
The series PLC can not be brought with the expansion module, but can be installed by the BD board to extend a small amount of I/O.
The series 1N through the installation of BD series PLC board, can achievee RS232, RS485, RS422 communication FR-D740-0.75K-CHT datasheet PDF catalog FR-D740-0.75K-CHT PDF datasheet.
All equipment is digital input and output point.
The total I/O points are not more than 30 points, and the input points are less than 16, thhe output points are less than 14 FR-D740-0.75K-CHT datasheet PDF catalog FR-D740-0.75K-CHT PDF datasheet.
Its MT series of PLC can drive 2 way servo or stepper, commonly used in the control system for a simple manipulator.