MITSUBISHI FR-D720-5.5K datasheet PDF catalog FR-D720-5.5K PDF datasheet

Power: 15kw.
Voltage: 400V.
Purpose: high frequency braking resistor.
The braking ability provided by the braking capacity is larger than that provided by the external braking resistor.
Can also be connected without built-in brake transistor inverter.
Three types of discharge resistors are available FR-D720-5.5K datasheet PDF catalog FR-D720-5.5K PDF datasheet.
Please select according to the required braking torque FR-D720-5.5K Power: 0.75kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity.
At the same time the installation options in the use of 75kW and above motor FR-D720-5.5K datasheet PDF catalog FR-D720-5.5K PDF datasheet. (the IP55 series has a built-in DC reactor.)
According to the motor power used to select the DC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) Station type: intelligent equipment station.
Remote input / output: 128 points.
Remote register: 32.
Occupied points: 8 points.
Transfer speed: 10Mbps.
Power supply: 240mA DC24V FR-D720-5.5K datasheet PDF catalog FR-D720-5.5K PDF datasheet.
Weight: 0.3kg.
FX3U-64CCL can be connected to the FX-PLC as an intelligent device station.
In addition, through the connection of the various manufacturers of machinery, can be used to set up the system.
Can be connected to FX3GA, FX3GE, FX3GC, FX3U and FX3UC of the host.
Connecting FX3UC, FX3GC requires FX2NC-CNV-IF or FX3UC-IPS-5V. Total input and output points: 16 points.
Input points: 16 points.
Output type: DC24V.
FX2N extension module.
The expansion module is an input and output expansion device of the power supply from the basic unit or the expansion unit,
Can choose the relay or crystal output models, to 8 points for the unit to connect.
Can be extended to FX3GA/FX3G, FX3GE, FX3GC, as well as FX3U, FX3UC series,
When connecting to FX3UC or FX3GC, you need FX2NC-CNV-IF or FX3UC-1PS-5V.
The number of connection points depends on the basic unit and the expansion unit. Maximum frequency: 50kHz.
Input points: 1 points.
Output form: transistor 2 point output.
Weight: 0.13kg.
FX2NC-1HC can achieve high speed counting by 1 phase //2 phase 50kHz hardware counter FR-D720-5.5K datasheet PDF catalog FR-D720-5.5K PDF datasheet.
Hardware comparator with high speed matching output function.
In the 2 phase count, can be set 1, 2, 4 frequency.
Can be achieved by PLC or external inputt to count the licensing / prohibition FR-D720-5.5K datasheet PDF catalog FR-D720-5.5K PDF datasheet.
Can also be connected to the linear drive output type of the encoder.
FX2NC-1HC can only be connected to FX3UC.