MITSUBISHI AJ35TB3-8D datasheet PDF catalog AJ35TB3-8D PDF datasheet

CPU:A3UCPU PLC is the same.
PLC program capacity: 30K step.
I/O points: 2084 points.
Processing speed (sequential order): 0.15 s/ step.
Control axis: up to 32.
Servo program capacity: 14K step.
Servo amplifier: SSCNET connected external servo amplifier.
PLC selection with the development of PLC technology, more and more types of PLC products,
Function is becoming more and more perfect, and its application is more and more extensive AJ35TB3-8D datasheet PDF catalog AJ35TB3-8D PDF datasheet AJ35TB3-8D
Different series of different models of PLC has different performance, applicable occasions also have different emphasis,
Price also has a greater difference. Therefore PLC selection,
Under the premise of meeting the control requirements,
Should consider the best performance to price ratio, a reasonable choice of PLC AJ35TB3-8D datasheet PDF catalog AJ35TB3-8D PDF datasheet. Bus connector conversion cable packageInput voltage range: AC100-120V/AC200-240V.
Output voltage: DC5V.
Output current: 8A.
For Q4ARCPU.
The control module monitors the power supply, the error
CPU state,
And its own error state.
It sends out
Error signal a6raf and open the corresponding
Relay output.
I/O points is an important indicator of PLC AJ35TB3-8D datasheet PDF catalog AJ35TB3-8D PDF datasheet.
Reasonable selection of I/O points can not only satisfy the control requirements of the system,
And the total investment of the system is the lowest.
The input and output points and types of PLC should be determined according to the analog quantity and switch quantity of the controlled object,
Generally an input / output element to take up an input / output point.
Taking into account the future adjustment and expansion,
In general should be estimated on the total number of points plus the amount of spare 20%~30%.
The following describes the centralized control system I/O points of the estimate. Output type: transistor drain.
Output points: 16 points.
Load voltage: DC24.
Load current: 2A.
Connection mode: terminal row.
Common public end points: 8.
Switching value, also known as logic, refers to only two values, 0 or 1, ON or OFF.
It is the most common control, it is the advantage of PLC control,
Is also the most basic application of PLC.
Switch volume control is designed to,
According to the current input combination of the switch quantity and the historry of the input sequence,
So that PLC generates the corresponding switching output,
In order to make the system work in a certain order AJ35TB3-8D datasheet PDF catalog AJ35TB3-8D PDF datasheet.
So, sometimes also known as the order control.
And seqquential control is divided into manual, semi-automatic or automatic AJ35TB3-8D datasheet PDF catalog AJ35TB3-8D PDF datasheet.
And the control principle is decentralized, centralized and hybrid control three.