MITSUBISHI A956GOT-SBD-M3 datasheet PDF catalog A956GOT-SBD-M3 PDF datasheet

QCPU (Q mode) bus connection.
1 joint.
Applicable model: A956WGOT. Cable length: 20 meters.
PC to GOT long distance connection cable.
For connection between GOT and GOT. 2 channel analog output module.
As well as analog input modules, the A1S62DA analog output component is built into a microprocessor,
It can convert binary data into voltage or current signals,
Offset and gain are set and stored in a microprocessor,
It also includes other features as follows:
2 output channels A956GOT-SBD-M3 datasheet PDF catalog A956GOT-SBD-M3 PDF datasheet A956GOT-SBD-M3
High resolution digital input, plus or minus 12000.
Total accuracy plus or minus 1%. Program memory capacity 14K.
Input and output points to the maximum 512 points.
A scan cycle of PLC must pass through three stages: input sampling, program execution and output refresh A956GOT-SBD-M3 datasheet PDF catalog A956GOT-SBD-M3 PDF datasheet.
PLC in the input sampling phase: first of all, in order to scan the sequence of all existing input latches in the input terminal of the state or input data read,
And write it into the corresponding input status register,
Refresh the input, then close the input port, enter the program execution stage. Input voltage range: AC100 ~ 120V/AC200 ~ 240V A956GOT-SBD-M3 datasheet PDF catalog A956GOT-SBD-M3 PDF datasheet.
Output voltage: DC5/12V.
Output current: 2.3A/1.5A.
I/O points is an important indicator of PLC.
Reasonable selection of I/O points can not only satisfy the control requirements of the system,
And the total investment of the system is the lowest.
The input and output points and types of PLC should be determined according to the analog quantity and switch quantity of the controlled object,
Generally an input / output element to take up an input / output point.
Taking into account the future adjustment and expansion,
In general should be estimated on the total number of points plus the amount of spare 20%~30%.
The following describes the centralized control system I/O points of the estimate.
Relay output interface circuit of PLC
Working process: when the internal circuit output digital signal 1,
There is a current flowing through, the relay coil has a current, and then the normally open contact is closed,
Provide load current and voltage.
When the internal circuit outpuuts a digital signal 0, there is no current flowing through it,
The relay coil does not have a current, and the normally open contact is broken off,
A current or voltage that is discoonnected from the load A956GOT-SBD-M3 datasheet PDF catalog A956GOT-SBD-M3 PDF datasheet A956GOT-SBD-M3 datasheet PDF catalog A956GOT-SBD-M3 PDF datasheet.
It is through the output interface circuit to the internal digital circuit into a signal to make the load action or not action.