MITSUBISHI Q50UDEHCPU Common Instructions Manual Q50UDEHCPU Strctured Programming Manual

Input points: 16 points.
Input voltage and current: 8mA AC100-120V (AC100V; 60Hz) /7mA (AC100V; 50Hz).
Response time: 20ms.
16 points / a common end.
18 point terminal station.
A variety of modules with excellent performance,
Meet the needs of various control from analog to location.
Q series module products include a variety of types of I/O, analog and positioning function module Q50UDEHCPU Common Instructions Manual Q50UDEHCPU Strctured Programming Manual Q50UDEHCPU
Can fully meet the switch, sensor, such as the input and output, temperature, weight, flow and motor, drive control,
As well as the requirements of high-precision control of the positioning of the industry, the control needs of various fields.
Can also be used in combination with the CPU module to achieve appropriate control Q50UDEHCPU Common Instructions Manual Q50UDEHCPU Strctured Programming Manual.
Continue to go beyond, to climb the peak of Q series.
Strengthen security function.
Can be set up to 32 characters of the file password.
In addition to the English letters, numbers, but also the use of special characters,
To further enhance the security of the password.
In addition, only pre registered devices are allowed to access CPU,
To intercept unauthorized access to unauthorized users Q50UDEHCPU Common Instructions Manual Q50UDEHCPU Strctured Programming Manual.
Therefore, it is important to prevent the outflow of important program assets and protect intellectual property rights.
Easy connection programming tool via ethernet.
Programming tools (Works2 GX, Developer GX) and CPU direct connection (1 to 1),
No need to carry out the IP address settings. And there is no need to select the cable, the straight line and the cross line can be used.
Therefore, this connection method and the use of USB, can easily communicate with the CPU,
Even the operators are not familiar with the network settings can easily establish a connection.Cable length 0.6 meters.
Extended substrate for connection.Control axis: maximum 32 axes.
Teaching running function: there (when using SV13).
To stop the speed control function at the specified location.
The servo motor can rotate at a predetermined speed,
After starting the specified location to stop the instruction,
Can be sett in advance to stop the location Q50UDEHCPU Common Instructions Manual Q50UDEHCPU Strctured Programming Manual.
You can change the speed by changing the value of the options at the time of the operation,
You can also change the acceleration / decelleration time Q50UDEHCPU Common Instructions Manual Q50UDEHCPU Strctured Programming Manual.
Phase compensation function.
The mixed function of virtual mode and real mode.
Smooth clutch linear acceleration / deceleration function.