MITSUBISHI Q24DHCCPU-VG Special Instructions Manual Q24DHCCPU-VG Programming Manual

"2 axes, SSCNET III type.
2 axis linear interpolation.
2 axis arc interpolation.
Control unit: mm, inch, degree, pulse.
Location data: 600 data / axis.
40 pin connector.
Through the SSCNET III cable connection to save wiring, the distance between the station up to 50m.
Absolute position system for determining the origin position is supported by the return data set operation Q24DHCCPU-VG Special Instructions Manual Q24DHCCPU-VG Programming Manual Q24DHCCPU-VG
In addition, the limit switch of the upper limit, the lower limit switch and the near point block signal input can be directly connected to the servo amplifier,
Thus greatly reducing the wiring requirements.
Easy to achieve high speed, high precision positioning control.
Support for multiple types of positioning control,
Including 2 ~ 4 axis 2 axis linear interpolation, circular interpolation, speed control and speed / position control, path switching control, constant speed control etc Q24DHCCPU-VG Special Instructions Manual Q24DHCCPU-VG Programming Manual. .
In addition, can use the "Configurator-QP GX" and other software,
Easy to set, monitor and debug. "3 slots; requires 1 AnS series PLC power modules;
Used to install large AnS series PLC module.
Base plate of AnS series PLC.
QA1S series PLC 3 slot main substrate Q24DHCCPU-VG Special Instructions Manual Q24DHCCPU-VG Programming Manual.
AnS series of modules can be installed. "Maximum control axis: 2 axis.
Connection mode with servo amplifier: SSCNET III /H connection type.
The maximum distance between the drive units: 100m.
Operation cycle: 0.88ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 2 points.
Color detecting set: 4 set.
Even the long distance wiring can be flexible.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus greatly reducing wiring.
In addition to positioning ccontrol and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc Q24DHCCPU-VG Special Instructions Manual Q24DHCCPU-VG Programming Manual. .
Positioning module (QD75MH) of the project annd the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS) Q24DHCCPU-VG Special Instructions Manual Q24DHCCPU-VG Programming Manual. "