MITSUBISHI Q10UDEHCPU SFC Manual Q10UDEHCPU Programming Manual

"Maximum control axis: 4 axis.
Connection mode with servo amplifier: SSCNET III /H connection type.
The maximum distance between the drive units: 100m.
Operation cycle: 0.88ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 4 points.
Color detecting set: 4 set Q10UDEHCPU SFC Manual Q10UDEHCPU Programming Manual .
Even the long distance wiring can be flexible Q10UDEHCPU
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc Q10UDEHCPU SFC Manual Q10UDEHCPU Programming Manual . .
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus greatly reducing wiring Q10UDEHCPU SFC Manual Q10UDEHCPU Programming Manual .
In addition to positioning control and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc..
Positioning module (QD75MH) of the project and the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS). "Conversion of series Q shell, Q series I/O slot used for installation.SI/QSI/H-PCF/ broadband H-PCF optical cable.
Double circuit.
Controller network (control station / common station) / remote I/O network (remote master station).
With external power supply function.
MELSECNET/H network module capable of composing large scale flexible network system.
The MELSECNET/H network system includes the PLC network of the control station and the communication between the stations and the remote I/O network in the remote station remote I/O station.
Optical fiber loop system...... High speed communication of 10Mbps/25Mbps is realized.
The distance between stations, the length of the tottal cable length, strong anti-interference Q10UDEHCPU SFC Manual Q10UDEHCPU Programming Manual .
Coaxial bus system...... Using low cost coaxial cable, the network construction cost is lower than that of the optical fiber loop network.
Twisted pair bus system Q10UDEHCPU SFC Manual Q10UDEHCPU Programming Manual . ..... Combined with high performance price ratio network module and twisted pair cable,
The construction cost of network system is very low.