MITSUBISHI Q10UDEHCPU Fundamentals Manual Q10UDEHCPU Strctured Programming Manual

Input and output points: 512 points.
Input / output data points: 8192 points.
Program capacity: 28k.
Basic command processing speed (LD command) S:0.2.
PLC in the program execution stage: according to the order of the user program order to store the order of each instruction,
After the corresponding operation and processing, the result is written to the output status register,
The contents of the output status register are changed with the execution of the program Q10UDEHCPU Fundamentals Manual Q10UDEHCPU Strctured Programming Manual Q10UDEHCPU
Output refresh phase: when all instructions are executed,
The output status register is sent to the output latch in the output refresh stage,
And through a certain way (relay, transistor or transistor) output, drive the corresponding output equipment Q10UDEHCPU Fundamentals Manual Q10UDEHCPU Strctured Programming Manual. Board module installation location: QS series power module mounting slot.
Suitable substrate module: QS034B.
Input power: AC100~120V.
Security PLC (secure programmable system) refers to the self or external components or the implementation of the failure of the agency,
Can still respond to and promptly cut off the output of the programmable system.
Different from ordinary PLC, security PLC not only can provide the function of ordinary PLC,
Safe control function can be realized,
Meet the requirements of the ISO 13849-1 EN and IEC 61508 control system safety related component standards Q10UDEHCPU Fundamentals Manual Q10UDEHCPU Strctured Programming Manual.
PLC security market mainstream has oilz (Pilz) PSS 3000, PSS 4000,
PSS 4000 in addition to the security process can also be processed outside the standard control procedures.
All the components in the security PLC adopt the redundancy structure,
Two processor processing for cross detection,
The processing results of each processor are stored in their respective memory,
Output is only when the processing result is in full agreement,
If any inconsistency occurs during the process, the system is immediately shut down. 1ch RS-232.
1ch RS-422/485.
Basic language programming module.
The position signal of the first axis servo amplifier, which is used on the motion CPU, is used as a trigger,
Starting from the programmable controller CPU to the second axis servo amplifier,
Time to output speed command of servo amplifier.
This time is the index of data transmission speed between CPU.
Ultra high speed processing, production time is shortened, better performance.
As applications become larger and more complex, it is necessary too shorten the system operation cycle time Q10UDEHCPU Fundamentals Manual Q10UDEHCPU Strctured Programming Manual.
The operation period can be shortened by the super high basic operation speed 1.9ns.
In addition to achieve in the past with the controol of single-chip high-speed control,
The system performance can be improved by reducing the total scan time,
To prevent any possible performance bias Q10UDEHCPU Fundamentals Manual Q10UDEHCPU Strctured Programming Manual.