MITSUBISHI Q100UDEHCPU Fundamentals Manual Q100UDEHCPU Strctured Programming Manual

Control axis: up to 32 axes.
Servo amplifier connection mode: SSCNET III /H (2 system).
Can be carried out with a high degree of control, free correspondence.
Large scale and medium scale system.
Maximum number of control axis: 32 axis (Q173DSCPU), 16 axis (Q172DSCPU).
Programmable controller CPU and C language controller can be selected according to the purpose Q100UDEHCPU Fundamentals Manual Q100UDEHCPU Strctured Programming Manual Q100UDEHCPU
By using 3 sets of Q173DSCPU, 96 axes can be controlled.
Support security monitoring function, visual system.Cable length 1.2 meters.
Extended substrate for connection.3 slots; requires 1 AnS series PLC power modules;
Used to install large AnS series PLC module.
Base plate of AnS series PLC.
QA1S series PLC 3 slot main substrate.
AnS series of modules can be installed Q100UDEHCPU Fundamentals Manual Q100UDEHCPU Strctured Programming Manual. "Maximum control axis: 16 axis.
Connection mode with servo amplifier: SSCNET III /H connection type.
The maximum distance between the drive units: 100m.
Operation cycle: 0.88ms, 1.77ms.
Interpolation function: linear interpolation (maximum 4 axis), 2 axis arc interpolation.
Color signal: 4 points.
Color detecting set: 16 set.
Even the long distance wiring can be flexible Q100UDEHCPU Fundamentals Manual Q100UDEHCPU Strctured Programming Manual.
The use of fiber optic cable, with high speed, high performance, high reliability of the servo system controller network.
In addition to the traditional positioning control, but also to support speed / torque control and synchronous control.
Use simple movement module setup tool",
Can easily perform positioning settings, monitoring and debugging, etc..
In addition, the data can be collected and displayed synchronously with the motion controller.
SSCNET III /H connection to save the wiring, the maximum distance between the station up to 100m,
Absolute position system can be easily supported.
The upper limit limit switch, the lower limit switch and the near point block signal are input by the servo amplifier,
Thus greatly reducing wiring.
In addition to positioning ccontrol and speed control, but also to perform synchronization control, cam control, torque control, touch pressure control, etc Q100UDEHCPU Fundamentals Manual Q100UDEHCPU Strctured Programming Manual. .
Positioning module (QD75MH) of the project annd the sequence of the previous model is highly compatible with the old model,
The project can be easily applied to the simple motion module (QD77MS) Q100UDEHCPU Fundamentals Manual Q100UDEHCPU Strctured Programming Manual. "