MITSUBISHI Q00JCPU-S8-SET Common Instruction 1/2 Manual Q00JCPU-S8-SET Programming Manual

Output: 2 channels.
Input (resolution): 0~12000; -12000~12000; 0~12000; -16000~16000.
Output DC0~20mA; DC-12~12V.
Conversion speed: 10ms/1 channel.
18 point terminal station.
Isolation between channels.
The possibility of expanding control with intelligent function.
At the same time, the channel isolation analog module realizes high isolation voltage,
Further improve the accuracy of the benchmark Q00JCPU-S8-SET Common Instruction 1/2 Manual Q00JCPU-S8-SET Programming Manual Q00JCPU-S8-SET
Provide support for process control using a general purpose programmable controller.
Flow meter, pressure meter, other sensors can be directly connected to analog input,
Control valve can also be directly connected to analog output.
Hardware and installation costs have been greatly reduced due to the need for an external isolation amplifier Q00JCPU-S8-SET Common Instruction 1/2 Manual Q00JCPU-S8-SET Programming Manual.
High insulation strength.
Can isolate electrical interference, such as current and noise, etc..
Standard analog input module.
Isolated analog input module.
No external isolation amplifier required.
Without the use of inter channel isolation analog modules.
Using the inter channel isolation analog module. Control axis: up to 32 axes.
Servo amplifier connection mode: SSCNET III /H (2 system) Q00JCPU-S8-SET Common Instruction 1/2 Manual Q00JCPU-S8-SET Programming Manual.
Can be carried out with a high degree of control, free correspondence.
Large scale and medium scale system.
Maximum number of control axis: 32 axis (Q173DSCPU), 16 axis (Q172DSCPU).
Programmable controller CPU and C language controller can be selected according to the purpose.
By using 3 sets of Q173DSCPU, 96 axes can be controlled.
Support security monitoring function, visual system.Three-phase 4 wire type.
Measuring circuit number: 1 circuits.
Measurement items: power consumption (consumption, regeneration), current, voltage, power, power factor, etc..
Power measurement module product group capable of simply measuring various energy information.
With only one module can be used to measure and power consumption (consumption and regeneration), reactive power, current, voltage, power, power factor and frequency of all kinds of detailed information.
No ladder program can continue to monitor the minimum and maximum values, can also perform 2 types of upper / lower limit alarm.
Only in the ON state can be used to measure the output of the output device.
Therefore, the amount of electricity and the quantity of electricity in the unit of the beat can be obtained during the operation of the equipment.
3 phase 3 wire products can be used to measure up to 4 circuits in one slot,
3 phase 4 wire productss can be used to measure up to 3 circuits,
So the electrical energy measurement can be carried out in a small space by the multi circuit products Q00JCPU-S8-SET Common Instruction 1/2 Manual Q00JCPU-S8-SET Programming Manual.
For example, a module ccan be used to measure other loads from the control panel trunk Q00JCPU-S8-SET Common Instruction 1/2 Manual Q00JCPU-S8-SET Programming Manual.
In addition, Works2 GX (version 1.90U and higher) can be used to easily set parameters.