MITSUBISHI MR-J3-500T4 CC-Link Manual MR-J3-500T4 INSTRUCTION MANUAL

Superior high efficiency IPM motor.
Output power: 3.7kw.
Rated speed: 1500r/min.
Voltage level: 400V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MR-J3-500T4 CC-Link Manual MR-J3-500T4 INSTRUCTION MANUAL. The length of the line: 2M.
IP level: IP65 MR-J3-500T4
Direct type.
The cable is not shielded.
Bending life: high bending life.
Connector kit for motor electromagnetic brake.
Cable for electromagnetic brake, for HF-KP/HF-MP series (motor shaft with side extraction). Cable length: 1.0m.
Amplifier CC-Link interface unit cable.
For MR-J2S-11KA (4) MR-J2S-22KA to (4).
Amplifier and CC-Link interface unit using 0 MR-J3-500T4 CC-Link Manual MR-J3-500T4 INSTRUCTION MANUAL. 5 m (1.64 ft) or shorter cables. Fiber length: 50 meters.
SSCNET III cable (long distance optical fiber, high bending life).
Joints for CN1A and CN1B. MR-J2M multi axis servo amplifier drive unit.
Rated output: 0.4kw.
The accuracy, stability, response characteristics and operating frequency of the main indicators of the servo control system are four aspects,
Especially in the frequency band width and precision MR-J3-500T4 CC-Link Manual MR-J3-500T4 INSTRUCTION MANUAL.
Frequency bandwidth of the system, the system frequency response characteristics of the system to reflect the servo system to track the fast. Type: general purpose AC servo amplifier MR-E series.
Rated output: 0.75kw.
Interface type: general purpose pulse interface.
KH003 special mark for Super MR-E.
High performance and easy to operate, reduce work load.
Enhanced system cost performance.
High performance, high precision positioning (servo motor encoder resolution: 131072).
High response.
Suppression of vibration by adaptive vibration suppression control.
Using personal computer and servo setup software to optimize tuning.
Has 2 types of intterfaces:
Position control and speed control with pulse train interface MR-J3-500T4 CC-Link Manual MR-J3-500T4 INSTRUCTION MANUAL.
The analog input interface is used for speed control and torque control. Cable length: 10m.
For MR-J2S-700A (4) /CP/CLL or less MR-J3-500T4 CC-Link Manual MR-J3-500T4 INSTRUCTION MANUAL.
Encoder for HC-SFS; HC-LFS; HC-RFS; 2000r/min HA-LFS; HC-UFS servo motor.
-H products have a long flex life.
Coding is not resistant to oil.