MITSUBISHI MR-J3-40T1 General-Purpose Interface Manual MR-J3-40T1 INSTRUCTION MANUAL

Drive: MR-H_ACN series built-in positioning function.
Rated output: 0.1KW.
In servo drive speed closed loop,
Rotor speed measurement accuracy is very important to improve the dynamic and static characteristics of the speed control loop.
In order to seek the balance between measurement precision and system cost, incremental photoelectric encoder is generally used as the speed measuring sensor,
The corresponding method is M/T velocity measurement MR-J3-40T1 General-Purpose Interface Manual MR-J3-40T1 INSTRUCTION MANUAL MR-J3-40T1
Although the M/T measurement method has a certain measurement accuracy and a wide range of measurement,
But this method has its inherent defects,
Mainly includes: the measurement period must be detected at least one complete encoder pulse, limiting the minimum detectable speed MR-J3-40T1 General-Purpose Interface Manual MR-J3-40T1 INSTRUCTION MANUAL.
2 control system for speed control of the timer switch is difficult to maintain synchronization,
Can not guarantee the accuracy of measurement in the situation where the speed change is larger.
Therefore, it is difficult to improve the speed tracking and control performance of servo drive by using the traditional speed loop design method.MITSUBISHI general purpose AC servo amplifier MR-J2 series MR-J3-40T1 General-Purpose Interface Manual MR-J3-40T1 INSTRUCTION MANUAL.
Rated output: 3.5kw.
Interface: general purpose interface.
Voltage: three phase AC200V.
MITSUBISHI servo system in the MITSUBISHI servo amplifier is widely used,
It can not only be used in the high precision position control and speed control of the working machinery and general industrial machinery,
Can also be used in the field of speed control and tension control.
By installing a personal computer with a servo setting software, the parameters setting, trial run, state display, and gain adjustment are performed.
MITSUBISHI servo system MR-J2S column is developed on the basis of the servo MR-J2 series with a higher performance and more features of the MITSUBISHI servo system,
The control modes are posittion control, speed control and torque control, as well as the switching control mode among them MR-J3-40T1 General-Purpose Interface Manual MR-J3-40T1 INSTRUCTION MANUAL. The length of the line: 10M.
IP level: IP65.
Cable outlet direction: the samee side of the motor shaft MR-J3-40T1 General-Purpose Interface Manual MR-J3-40T1 INSTRUCTION MANUAL.
Bending life: high bending life.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction).