MITSUBISHI MR-J2S-350B Manual MR-J2S-350B INSTRUCTION MANUAL

The length of the line: 10M.
IP level: IP65.
Cable lead out direction: motor shaft different side.
Bending life: standard.
The cable is not shielded.
Encoder with cable (motor side); for HF-KP/HF-MP series (motor shaft with side extraction). Drive unit.
MITSUBISHI universal AC servo amplifier MELSERVO-J4 series MR-J2S-350B Manual MR-J2S-350B INSTRUCTION MANUAL.
Rated output: 30kw.
Interface: SSCNET III /H MR-J2S-350B
Power supply: three phase AC200V.
Support position control, speed control, torque control.
Position control to follow the position instructions.
When the control is inserted, the position control is performed.
Speed control follows the speed command to control the speed within a certain range.
Torque control to follow the torque command to control the stable torque MR-J2S-350B Manual MR-J2S-350B INSTRUCTION MANUAL.
Function of switching amplitude. The increase in the process of switching and stopping,
And in the operation of the use of the switching signal, switching growth. MITSUBISHI motor universal AC servo amplifier MELSERVO-J3 series.
Rated output: 15.0kw.
Interface type: CC-Link communication type (built-in positioning function).
Power specification: three phase AC200V.
Positioning operation by setting position and rotational speed data in the positioning table and receiving the start signal from the main controller MR-J2S-350B Manual MR-J2S-350B INSTRUCTION MANUAL.
The setting of the position and speed of the positioning table, as well as the start and stop operation can be completed through CC-Link communication.
By using the MR-J3-D01 extension IO unit, the DI/O instruction can be used to select and locate the table.
(CC-Link can not be used for MR-J3-D01 communications).
With built-in positioning function of the servo amplifier, can be set through the CC-Link communications and speed data. (corresponding to the CC-Link version: Ver.1.10)
Can be achieved through the CC-Link communications to start, stop and monitoring and other operations.
Serial communicatioon reduce wiring MR-J2S-350B Manual MR-J2S-350B INSTRUCTION MANUAL.
Distributed servo control system can be built by CC-Link communication.
The parameters of unit MR-PRU03 (optional) the parameter setting, operation and monitoring more convenient.

The servo amplifier can be used for speed control operation MR-J2S-350B Manual MR-J2S-350B INSTRUCTION MANUAL.
When the two stations are occupied, the speed can be set directly by the remote register.