MITSUBISHI MR-H200ACN Manual MR-H200ACN Instruction Manual

Superior high efficiency IPM motor.
Output power: 37kw.
Rated speed: 1500r/min.
Voltage level: 200V.
IPM motor MM-EFS series can not be used to run the power frequency power.
The total wiring length of the IPM motor shall not exceed 100m.
1 inverters can not connect multiple IPM motors at the same time MR-H200ACN Manual MR-H200ACN Instruction Manual. MITSUBISHI general purpose AC servo amplifier MR-J2 series MR-H200ACN
Rated output: 0.2kw.
Interface: single axis positioning built-in type.
Voltage: single phase AC200V.
High response.
High precision positioning.
High level automatic tuning, can easily achieve gain settings.
Adopting adaptive vibration control and reducing vibration.
With a computer combination, using the software to achieve the best tuning MR-H200ACN Manual MR-H200ACN Instruction Manual.
Pulse sequence input (position, speed control), analog input (speed, torque control) two purposes.
Simple operation.
The socket is arranged on the front panel, and is convenient to connect.
Using the socket, wiring easy.
Setting method and J2Super with interchangeable. MITSUBISHI general purpose AC servo amplifier MR-J2 series.
Rated output: 0.6kw.
Interface: SSCNET type.
Voltage: single phase AC200V MR-H200ACN Manual MR-H200ACN Instruction Manual.
MR-J2 series server system has the ability to carry out a higher precision control,
Using high performance CPU, greatly improve the responsiveness of the product,
Speed loop frequency response increased to 550HZ.
Various series of servo motors are suitable for different control requirements,
The encoder on the servo motor supports ABS mode,
As long as the servo amplifier on the other plus batteries,
Can form an absolute position system. Drive: MR-H_ACN series built-in positioning function.
Rated output: 5.0KW.
In servo drive speed closed loop,
Rotor speed measurement accuracy is very important to improve the dynamic and static characteristics of the speed control loop.
In order to seek the balance between measurement precision and system cost, incremental photoelectric encoder is generally used as the speed measuring sensor,
The corresponding method is M/T velocity measurement.
Although the M/T measurement method has a certain measurement accuracy and a wide range of measurement,
But this method has its inherent defects,
Mainly includes: the measurement period must be detected at least one complete encoder pulse, limiting the minimum detectablle speed MR-H200ACN Manual MR-H200ACN Instruction Manual.
2 control system for speed control of the timer switch is difficult to maintain synchronization,
Can not guarantee the accuracy of measurement in the situation where the speed change is largger MR-H200ACN Manual MR-H200ACN Instruction Manual.
Therefore, it is difficult to improve the speed tracking and control performance of servo drive by using the traditional speed loop design method.