MITSUBISHI GT2510F-VTND Manual GT2510F-VTND SAFETY PRECAUTIONS

Protective film for 15 inch screen.
Scrub, 5.
Applicable model: GT16. Cable length: 0.2m.
Connection between RS-422/485 (connector) and RS-422 cable (D-SUB9 pin) for GT16.
Applicable model: GT16. Cable length: 6m.
Connection between a connector adapter box and a smart GOT.
Applicable model: HandyGOT GT2510F-VTND Manual GT2510F-VTND SAFETY PRECAUTIONS. Cable length: 13m.
The connection between the CC-LINK interface unit and the smart GOT GT2510F-VTND
Applicable model: HandyGOT. Series: multimedia and advanced features and features of a variety of high-performance models.
Screen size: 8.4 inches.
Display color: 256 color or more color.
Installation type: compatible with multimedia and video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle) GT2510F-VTND Manual GT2510F-VTND SAFETY PRECAUTIONS.
Host frame color: black.
Power type: AC100~240V.
Communication interface: with built-in RS-422.
High performance models with multimedia and advanced features and functionality (including embedded communications capabilities).
User storage capacity: 15MB (GT16__-VNB__:11MB).
With HOST USB and device USB port.
Standard Ethernet, RS-422/485 and RS-232 ports.
Support multimedia and video /RGB units GT2510F-VTND Manual GT2510F-VTND SAFETY PRECAUTIONS.
Analog touch panel.
Do not let the touch screen surface with water drops or other soft things stick to the surface,
Otherwise, the touch screen is easy to mistake that there is a hand touch caused by surface acoustic wave screen is not allowed.
In addition to cleaning the dirt on the surface of the touch screen,
You can use a soft dry cloth or a cleaning agent to clean out the center of the screen carefully,
Or use a dry soft cloth dipped in industrial alcohol or glass cleaning fluid to clean the touch screen surface.
Touch screen response is slow if you use a hand or other touch to touch the surface acoustic wave touch screen,
This shows that it is likely that the touch screen system has been obsolete, the internal clock frequency is too low,
Or because there is water in the surface of the touch screen to make the touch screen mobile, rapid response recovery,
To replace or upgrade the system must, or use dry cloth touch screen on the surrface of the water GT2510F-VTND Manual GT2510F-VTND SAFETY PRECAUTIONS.
If the user is operating the touch screen, the direction of the touch move is to the left,
But the cursor of the system moves to the right,
The failure may be due to the conneection of the control box and the touch screen connected to the connector or the touch screen,
Users as long as the direction of the re exchange of it GT2510F-VTND Manual GT2510F-VTND SAFETY PRECAUTIONS.