MITSUBISHI GT2508-VTBD Non-Mitsubishi Products 1 Manual GT2508-VTBD Connection Manual

Bus cables used for GOT1000 to replace the ferrite cores used in the existing GOT-A900 bus cables.
Applicable models: GT16, GT15, GT11. Protective film for 15 inch screen.
Transparent, 5.
Applicable model: GT16. For video input (NTCS/PAL) 1 channel motion picture playback.
Applicable model: GT16. Cable length: 10m GT2508-VTBD Non-Mitsubishi Products 1 Manual GT2508-VTBD Connection Manual.
For QnA/ACPU/ motion controller CPU (A Series) /FXCPU GT2508-VTBD Connection between (D-SUB25 pin connector) and GOT.
For the connection between FA-CNV*CBL and GOT.
Connector for serial communication unit and GOT.
For the connection between AJ65BT-G4-S3 and GOT.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21. For video input (NTSC/PAL) 4ch.
Applicable model: GT27 GT2508-VTBD Non-Mitsubishi Products 1 Manual GT2508-VTBD Connection Manual. Bus cables used for GOT1000 to replace the ferrite cores used in the existing GOT-A900 bus cables.
Applicable models: GT16, GT15, GT11, GT27, GT25. A series of high performance models that are widely used in network or single machine work environments.
Screen size: 8.4 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: VGA (640 x 480).
Display device: TFT color (high brightness, wide viewing angle) GT2508-VTBD Non-Mitsubishi Products 1 Manual GT2508-VTBD Connection Manual.
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system.
In order to ensure tthe normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT2508-VTBD Non-Mitsubishi Products 1 Manual GT2508-VTBD Connection Manual GT2508-VTBD Non-Mitsubishi Products 1 Manual GT2508-VTBD Connection Manual.