MITSUBISHI GT2103-PMBDS Microcomputers, MODBUS/Fieldbus Products, Peripherals Manual GT2103-PMBDS Connection Manual

Cable length: 0.7m.
For the connection between QnAS/AnSCPU/ motion controller GOT (A Series) and CPU.
Applicable models: GT16, GT15, GT11. Cable length: 10m.
For connection between FXCPU (MINI-DIN8 pin connector) and GOT.
Connection between FXCPU communication function extension board (MINI-DIN8 pin connector) and GOT MODBUS/Fieldbus Products.
Applicable models: GT16, GT15, GT11, HandyGOT, GT10, GT27, GT25, GT23,, GT21 GT2103-PMBDS 3.8 inches.
Surface treatment: anti reflective film.
Protective film color: No.
USB protective cover parts: no openings.
Set number: 5.
Applicable model: GT21. Cable length: 0.2m.
For bar code reader (D-SUB9 pin, header) and GOT (MINI-DIN6 pin, male head) RS-232 connection between.
Applicable models: GT11, GT21 MODBUS/Fieldbus Products. USB interface protection cover on the front panel of the host computer (for replacement).
For 15 inches /12.1 inches /10.4 inches /8.4 inches.
Applicable model: GT16. For video input (NTSC/PAL) 4ch.
Applicable model: GT27. Cable length: 13m.
The connection between the CC-LINK interface unit and the smart GOT.
Applicable model: HandyGOT. A series of high performance models that are widely used in network or single machine work environments MODBUS/Fieldbus Products.
Screen size: 12.1 inches.
Display color: 256 color or more color.
Installation type: compatible with video /RGB.
Resolution: SVGA (800 x 600).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black.
Power type: DC24V Peripherals Manual GT2103-PMBDS Connection Manual.
Communication interface: with built-in RS-422.
Ideal model for high performance in a network or independent operation environment Peripherals Manual GT2103-PMBDS Connection Manual.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system Peripherals Manual GT22103-PMBDS Connection Manual GT2103-PMBDS Microcomputers.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two oor more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly MODBUS/Fieldbus Products.