MITSUBISHI GT1685M-STBA Manual GT1685M-STBA User's Manual

A series of high performance models that are widely used in network or single machine work environments.
Screen size: 5.7 inches.
Display color: 256 color or more color.
Mounting type: panel mounting type.
Resolution: QVGA (320 x 240).
Display device: TFT color (high brightness, wide viewing angle).
Host frame color: black GT1685M-STBA Manual GT1685M-STBA User's Manual.
Power type: DC24V.
Communication interface: with built-in RS-422 GT1685M-STBA
Ideal model for high performance in a network or independent operation environment.
User storage capacity: 9MB (GT15__-VNB_:5MB).
Device USB port.
Standard RS-232 interface.
Support video /RGB unit.
If the capacitive touch screen is in the middle of the operation, the display resolution or display mode of the touch screen is changed again,
Or the refresh rate of the touch screen controller is adjusted by itself, and the cursor and the touch point can not be felt when the cursor is not corresponding to the touch point,
Must be re calibrated to the touch screen system GT1685M-STBA Manual GT1685M-STBA User's Manual.
In order to ensure the normal operation of the touch screen system, in addition to ensure the proper installation of the system software,
Must also remember that in a host do not install two or more than two kinds of touch screen driver,
This will cause the system to run in conflict, so that the touch screen system can not be used properly GT1685M-STBA Manual GT1685M-STBA User's Manual. Protective film for 8.4 inch screen.
Transparent, 5.
Applicable model: GT16. Protective film for 5.7 inch screen.
Transparent, 5.
Applicable model: GT105. "Series introduction: with a variety of advanced features of the compact model.
Screen size: 5.7 inches.
Display color: 256 color or more color.
Installation type: hand held.
Resolution: QVGA (320 x 240).
Display device: STN monochrome.
Host frame color: black.
Power type: DC24V.
Communication interface: with built-in RS-422.
The first characteristic of touch screen:
Transparent, it directly affects the visual effect of touch screen.
The problem of transparency is the degree of transparency, infrared technology, touch screen and surface acoustic wave touch screen is separated by a layer of pure glass,
Transparency can be considered a leader, the other touch screen this is a good scrutiny, transparency",
The touch screen industry, is a very broad concept, many touch screen is a multilayer composite film,
It''s not enough to generalize its visual effect with only a little transparency,
It should incclude at least four characteristics: transparency, color distortion, reflection and clarity, but also,
For example, the degree of reflection, including the degree of specular reflection and diffractioon,
But the touch screen surface diffraction reflection has not reached the extent of the CD disk,
For users, these four metrics are basically enough GT1685M-STBA Manual GT1685M-STBA User's Manual GT1685M-STBA Manual GT1685M-STBA User's Manual. "