MITSUBISHI FX3UC-16MT/DSS-P4 Basic & Applied Instructions Edition Manual FX3UC-16MT/DSS-P4 PROGRAMMING MANUAL

Input and output points: 30 points.
Power supply: AC100-240V.
Input points: 16 points.
Output points: 14 points.
Output form: relay output.
Power consumption: 21W.
Weight: 0.45KG.
Outline dimension: 100x90x75mm.
A new application model.
FX3SA is a basic model on the basis of the basic performance of FX1S above the expansion of the expansion of the new model FX3UC-16MT/DSS-P4 Basic & Applied Instructions Edition Manual FX3UC-16MT/DSS-P4 PROGRAMMING MANUAL FX3UC-16MT/DSS-P4
FX3SA is applicable to all kinds of fields of small scale equipment which need to simulate the quantity and function of MODBUS and Ethernet.
Basic models suitable for small scale control.
Compact but powerful,
At the same time, the analog quantity and communication function, etc.. MITSUBISHI inverter FR-F740 series.
Voltage level: three phase 400V FX3UC-16MT/DSS-P4 Basic & Applied Instructions Edition Manual FX3UC-16MT/DSS-P4 PROGRAMMING MANUAL.
Frequency converter capacity: 250KW.
The main circuit of the inverter can be divided into two categories in general: voltage type is the voltage source of the DC converter for AC inverter,
The filtering of the DC circuit is the capacitance; the current mode is the DC conversion of the current source to the AC inverter,
The DC loop filter is the inductor.
Why is the frequency of the inverter voltage proportional to the change?
The electromagnetic torque of any motor is the result of the interaction between the current and the magnetic flux, the current is not allowed to exceed the rated value, otherwise it will cause the heating of the motor FX3UC-16MT/DSS-P4 Basic & Applied Instructions Edition Manual FX3UC-16MT/DSS-P4 PROGRAMMING MANUAL.
Therefore, if the magnetic flux decreases, the electromagnetic torque will decrease, which leads to the reduction of the load carrying capacity. Input points: 32 points
Input mode: DC24V (drain type).
Connection status: connector.
In order to extend the input output of the device.
Also has a built-in power supply products.
The maximum number of points for the input and output is 256.
Expansion module: up to 16 units (in addition to the power expansion module)
The total number of CC-Link, AnyWireASLINK, and Bitty series of remote I/O is 512 points. Max input / output points: 48 points.
Power supply voltage: 24VDC.
Input points: 24 points.
Output points: 24 points.
Output type: relay.
Power consumption: 30W.
Weight (kg):0.85.
Size (WxHxD) mm:182x90x87.
Note recording function, Component annotation can be recorded in the program register.
Online program editor, online change the program will not lose the working hours or stop production operation.
RUN/STOP switch, running on panel / stop switch easy to operate.
Remote maintenance, remote programming software can monitor, upload or uninstall programs and data via modem communications
Password protection, using a eight digit password to protect your program.
Clock function and hour mmeter function, all of the PLC FX2N has a real-time clock standard FX3UC-16MT/DSS-P4 Basic & Applied Instructions Edition Manual FX3UC-16MT/DSS-P4 PROGRAMMING MANUAL.
Continuous scanning function, to define the operation cycle for the application off the continuous scan time FX3UC-16MT/DSS-P4 Basic & Applied Instructions Edition Manual FX3UC-16MT/DSS-P4 PROGRAMMING MANUAL.
Input filter adjustment function, you can use the input filter to smooth the input signal (in the basic unit x000 to x017).