MITSUBISHI FX3U-64MT/DSS Hardware Edition Manual FX3U-64MT/DSS USER'S MANUAL

Input and output points: 48 points.
AC power supply: AC100~240V.
Input points: 24 points.
Output points: 24 points.
Output form: transistor output (source).
Weight: 0.85kg.
Input signal voltage: DC24V.
FX2N series expansion unit
Expansion unit is an input and output expansion device with a built-in power supply FX3U-64MT/DSS Hardware Edition Manual FX3U-64MT/DSS USER'S MANUAL.
As with the basic unit, the extension unit can be connected to a variety of input and output and special extension equipment FX3U-64MT/DSS
Can connect to FX3GA/FX3G, FX3GE and FX3U.
AC power model, the built-in maximum DC24V 250mA/460mA supply power.
Because all models of FX series are built in high speed counter,
So the high speed control can be realized by the simple procedure.
The input of the basic unit is built in the anti jitter filter,
One part as digital filter,
Sensitivity adjustment unit can reach 1ms FX3U-64MT/DSS Hardware Edition Manual FX3U-64MT/DSS USER'S MANUAL.
Using high speed counter automatically adjusted to the minimum value.
Through the high cost of the built-in positioning function and the expansion function to increase the number of control axis.
Extended function expansion board and special adapter,
Data links and communication with external serial devices FX3U-64MT/DSS Hardware Edition Manual FX3U-64MT/DSS USER'S MANUAL. Total points: 40 points.
Input points: 24 points.
Output points: 16 points.
Voltage: AC220V.
Output type: transistor.
Outline dimension: 130*75*90.
FX1N series is a very powerful micro PLC,
Can be extended to up to 128 I/O points,
And can increase the special function module or the expansion board.
Communication and data link function options make FX1N in the volume, communication and special function modules and other important applications is very perfect. Power: 5.5kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table.
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necesssary to take protective measures and cooling FX3U-64MT/DSS Hardware Edition Manual FX3U-64MT/DSS USER'S MANUAL.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between thhe short circuit chip, in addition to connecting the DC reactor FX3U-64MT/DSS Hardware Edition Manual FX3U-64MT/DSS USER'S MANUAL.
The installation of thermal relay, to avoid overheating and burn the braking resistor.