MITSUBISHI FX3U-48MT/DS Manual FX3U-48MT/DS HARDWARE MANUAL

Power: 0.75kw.
Purpose: high frequency braking resistor.
The use rate of the built-in regenerative brake of the transducer can be promoted.
When using the FR-ABR type brake resistor, the short circuit piece between the terminal PR-PX is removed. Does not remove the short circuit chip will lead to overheating of the brake resistor FX3U-48MT/DS Manual FX3U-48MT/DS HARDWARE MANUAL.
The utilization rate of the regenerative braking should be less than the allowable brake use rate in the above table FX3U-48MT/DS
With the operating frequency of the brake resistor to reach 300 degrees C or higher, it is necessary to take protective measures and cooling.
MYS type resistor can be used. But please pay attention to the allowable brake use rate.
Do not remove the terminal P/+ and P1 between the short circuit chip, in addition to connecting the DC reactor FX3U-48MT/DS Manual FX3U-48MT/DS HARDWARE MANUAL.
The installation of thermal relay, to avoid overheating and burn the braking resistor. Power: 18.5kw.
Purpose: to suppress the power harmonics.
Improve the power factor, reduce the input side of the high harmonic current.
Make sure that this option is installed in the FR-A820-03800 (75K) and FR-A840-02160 (75K) and above capacity and above capacity FX3U-48MT/DS Manual FX3U-48MT/DS HARDWARE MANUAL.
At the same time the installation options in the use of 75kW and above motor. (the IP55 series has a built-in DC reactor.)
According to the motor power used to select the DC reactor.
(when the inverter capacity is greater than the motor capacity, is still based on the motor capacity to choose.) MITSUBISHI inverter series: FR-A800.
Voltage level: three phase 400V.
Power: 110kw.
SLD converter rated current: 325A.
Structure and function: Standard model.
Type: CA.
Substrate coating: have.
Mirror like ultra fine processing.
In order to adapt to the new material diversification, the machine adopts the most cutting-edge technology, more than ever more slim hard.
In order to be able to realize the fine cutting, grinding on the hard and hard material,
The need for high-speed operation has becoome more and more strong FX3U-48MT/DS Manual FX3U-48MT/DS HARDWARE MANUAL.
In order to cope with the increasing demand of logistics, every port in the world has a crane in every day.
A container filled with cargo.
We can achieve a new type of inverrter products under the conditions of low speed and high torque to achieve smooth cargo handling operations,
Carry on the smooth movement to the heavy FX3U-48MT/DS Manual FX3U-48MT/DS HARDWARE MANUAL.